Furniture of America Ribeira CM7252CK User manual

1. Place the headboard (#1) face down onto
a protected surface. Then prepare 6 bolt
assemblies by first inserting a lock washer
(#C) onto the bolt (#A) then a flat washer
(#D) onto that same bolt (#A).
2. Align the headboard legs (#2) to each side
and insert 3 bolt assemblies into each leg
and secure using the Allen wrench (#I).
3. Prepare 4 bolt assemblies by first ins-
erting a lock washer (#C) onto the bolt
(#B) then a flat washer (#D) onto that
same bolt (#B). Align each end of the
headboard support (#3) to the legs and
insert 2 bolt assemblies into each end.
Secure using the Allen wrench.
1. Insert 2 threaded bolts (#E) into the holes along the sides of
the headboard (#1) and footboard (#4). Turn right to tighten.
Then place the side rails (#5) onto those threaded bolts (#E).
2. From within the side rails (#5), apply
a u-square washer (#F) then a hex
nut (#G) onto the threaded bolts
(#E). Secure using the wrench (#J). Remove drawers

Place the slat kit (#6) onto the side rails
(#5), then insert a screw (#H) into each
end. Secure using a Phillips screwdriver.
Lay the slat kit (#6) face down onto a protected surface, then place the center rail (#7).
Insert the threaded ends of the support legs (#8) into the holes along the center rail
(#7) and turn right to tighten. Adjust the leveler by according to the ground level.