Furniture of America CM3187T User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3187T
Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-11-21
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED

Page 2 of 5

Parts List
#1 x 1 pc
Table Top
#2 x 1 pc
Leaf
#3 x 4 pcs
Leg
#A x 8 pcs
Hex Nut
#B x 8 pcs
Lock Washer
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Flat Washer
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly.ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.
MD
#D x 1 pc
Wrench
Page 3 of 5
Hardware List

I. With the help of another person, carefully place the table top
(#1) facing down on a protected surface.
II. Align the 4 legs (#3) with the pre-drilled holes on the bottom
corners of the table top (#1).
III. Insert FIRST the flat washer (#C) onto the threaded stud of the
legs (#3) and then the lock washer (#B) onto the SAME stud, in
that order. Secure the hex nut (#A) onto the same stud using the
wrench (#D) to tighten the parts together.
IV. Carefully turn the completed table upright. Make sure the table
is rested on a flat surface and does not feel loose or wobbly. If it
does, double check that the bolts are secured and properly
tightened.
Turn right (clockwise) to tighten
Page 4 of 5
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs

Page 5 of 5
I. To insert the leaf (#2), unlock the latches located under the table
top (#1).
II. Once unlocked, slide outward on both ends of the outer two-
piece table top (#1) until there is sufficient opening to place the
leaf (#2). Then slide inward on both ends of the outer two-piece
table top (#1) until they are touching and sitting flush with the
leaf (#2).
III. Secure the parts together by locking the latches located under
the table top (#1).
ASSEMBLY IS COMPLETED