Gama Sonic BAYTOWN II User manual

BAYTOWN II SOLAR LAMP
US Patent # 7172307
Instruction Manual
Model: GS-105FPW
GS-105F
GS-105 W
GS-105 P

Introduction
Thank you for your purchase. GAMA SONIC® solar-charged accent lighting
eliminates the problems associated with most solar lighting available today.
GAMA SONIC® solar-charged lights are brighter and last all night with a typical
solar charge. Unique design, superior light output and numerous installation
options confirm the outstanding value of our product.
GAMA SONIC® has been recognized as a worldwide leader in the lighting
industry for over 20 years. The company also offers unique multi-purpose
rechargeable products that range from fans with built in radios to emergency
lighting products.
Please read the instruction manual carefully to obtain the best results from
your purchase.
Tools that are needed but not supplied with your lamp are: A screwdriver
Solar Lamp Location:
For optimum light duration throughout the night, it is very
Important to place your solar lamp in a spot where it will receive the maximum
amount of direct sunlight throughout the day.
Note:
For best results, allow the solar lamp to be charged for two consecutive sunny
days.

What's Inside?
Open your package and remove the contents. Check to make sure all pieces are
present and accounted for.
GS-105FPW PARTS
A
Finial
B
Top
D
Fixture
E
3”Fitter
F
Wall bracket
G
Flat base
C
Window Frame

Operation Instructions
1. In case your light is already installed, remove part (B) from part (C) by
unscrewing the 2 screw caps. Otherwise skip to step 2.
2. Turn the operation switch (Fig. J) to “summer” (for greater brightness)
or “winter” (for longer duration) position, the solar lamp will
automatically operate dusk to dawn.
3. Reattach part (B) to part (C) and secure with the 2 screw caps.
Lamp Assembly
A
B
C1
D
C3
C2
E
F
G
NOTE: Turn the Operation
switch to ON position, before
completing this step.

Installation Instructions
GS-105F
Note: If you are replacing an existing gas/electric post light, you must
consult a certified technician to disconnect them before installation.
1. Position Part (D1) on top of your existing 3” post and tighten it using
the screws provided.
Installation Instructions
GS-105P
Note: There are specific types of screws for specific surfaces. If unsure of
the appropriate type of screw to use on your desired surface please consult
a professional.
1. Use a drill to make two holes in the desired surface
2. Place the white screw anchors into the holes, place the lamp
in line (D2) with the holes and secure with the provided
screws.
Installation Instructions
GS-105W
Note: Make sure lamp is mounted so full sun exposure is possible.
1. Use a drill to make two holes in the desired wall
2. Place the white screw anchors into holes, place the lamp’s wall
bracket (D3) in line with the holes and secure with the provided
screws.
Replacing the Batteries
(After several years of use, the battery may need replacing).
Note: The lamp is designed to run with one battery but a second, optional
battery, can be installed for longer duration of light each night.
1. Unscrew the two screw caps and detach part (B) from part
(C). Make sure the switch is in the OFF (O) position.
2. Unscrew the battery compartment screw, (Fig. I) located on
the silver reflector and remove the compartment door.
3. Unclip the connector and remove the old battery. Make sure
the new battery is high quality 3.2V/1,500mAh Lithium-ion
Rechargeable battery with connector.
Gama Sonic part #GS3V15
4. Clip on new battery and install into the battery compartment.
Screw back battery compartment screw.
5. Reattach part (B) to part (C) and secure with the 2 screw caps.

WARNING
Do not dispose of Li-Ion battery in the regular trash, municipal waste stream or
by fire as batteries may leak or explode. Do not open, short circuit, or mutilate
batteries as injury may occur. Preserve our environment by recycling Li-Ion
batteries or disposing of them in accordance with local, State and federal
regulations. Do not mix old and new batteries.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum
performance. Do not use any type of solvent for cleaning and be careful not to
put too much pressure on the solar panels while cleaning.
Troubleshooting
If your solar charged light does not come on at dusk despite observance of all
the instructions, please try the following steps:
1. Make sure that the solar lamp is not being affected by any
other light source.
2. Ensure the solar lamp is not positioned in the shade during
the day.
3. Make sure the switch in the lamp head is in On (Summer or
Winter) position.
4. Check that the batteries are installed correctly.
Note: The performance of the solar lamp will vary with the time of year. It will
deliver more light when it has had a full day in the sun rather than a day in
overcast weather.
WINTERTIME TIPS
For optimal performance, be sure to remove any snow or debris accumulation
from solar panel(s). A solar panel free of debris will charge the batteries much
more efficiently.
WARNING
Please keep out of reach of children.