Gama Sonic BAYTOWN GS-106FPW User manual

1
Visit our website or download the latest version of your instruction manual:
www.gamasonic.com or www.gamasonic.com/user-guides
BAYTOWN SOLAR LAMP
US Patent # 7172307
Instruction Manual
Model: GS-106FPW
GS-106W
GS-106P
GS-106F

2
Introduction
Thank you for your purchase. GAMA SONIC®solar charged accent lighting eliminates the
problems associated with most solar lighting available today. GAMA SONIC®solar charged
lights are brighter and last all night with a typical solar charge. Unique design, superior light
output and numerous installation options confirm the outstanding value of our product.
GAMA SONIC®has been recognized as a worldwide leader in the lighting industry for over 20
years. The company also offers unique multi-purpose rechargeable products that range from
party lights to emergency lighting products.
For technical assistance and more information call our Toll Free number:
1-800-835-4113 (only within the US) or visit our website at: www.gamasonic.com.
Please read the instruction manual carefully to obtain the best results from your purchase.
Tools that are needed but not supplied with the solar post lamps are: a screw driver, power drill.
Solar Lamp Location:
For optimum light duration throughout the night, it is very important to place your solar lamp in a
spot where it will receive the maximum amount of direct sunlight throughout the day.
NOTE: For best results, the solar lamp must be charged for two sunny days in the ON position.
A
B
C
D
E
F
G
Fig. 1
C
C
B
B
A
A
GS-106W
GS-106F
GS-106P

3
Operation Instructions
1. Remove the Top part (B) from Body part (C) by unscrewing the 2 screw caps. Turn
the operation switch (Fig. 2) to either Bright white or warm white position according
your preferences. The Solar Lamp will automatically operate dusk to dawn.
2. Reattach the Top part (B) to the Body part (C) and secure with the 2 screw caps.
Installation Instructions
1. Install finial by screwing part (A) on the Top part (B) (Fig. 1).
GS-106P
1. Screw in part G into part C as shown in Fig. 1.
2. Use a drill to make two holes in the desired surface,
3. Place the white screw anchors into the drill holes, place the lamp in line with the holes
and screw down with the provided screws.
Note: There are specific types of screws for specific surfaces. If unsure of the appropriate type
of screw to use on your desired surface please consult a professional.
GS-106W
NOTE: For best results locate your solar lamp facing the south.
1. Screw part E into part D as shown in Fig. 1.
2. Screw part C (full lamp) into part D.
3. Remove the silver back bracket by removing the 2 screw caps on the front face
of the wall mount.
4. Screw the silver bracket onto the desired surface.
5. Place lamp onto bracket and replace 2 wall mount screw caps.
GS-106F
NOTE: If you are replacing an existing gas/electric post light, you must consult a
certified technician to cancel them before installation.
1. Screw part F into part C as shown in Fig. 1.
2. Position Part (F) on top of the existing 3” post and tighten it using the screws provided.
Fig. 2

4
Replacing the Batteries
(After several years of use, the battery may need replacing).
1. Unscrew the two screw caps and detach part (B) from part
(C). Make sure the ON/OFF switch is in the OFF (O)
position.
2. Unscrew the battery compartment screw, (Fig. 3) located
on the silver reflector and remove the compartment door.
3. Unclip the connector and remove the old battery. Make
sure the new battery is high quality 3.2V/1,500mAh Lithium-ion Rechargeable
battery with connector.
4. Clip on new battery and install into the battery compartment. Screw back battery
compartment screw.
5. Reattach part (B) to part (C) and secure with the 2 screw caps.
** Batteries are available for purchase at www.gamasonic.com
WARNING: Do not dispose of Li-Ion battery in the regular trash, municipal waste stream or by
fire as batteries may leak or explode. Do not open, short circuit, or mutilate batteries as injury
may occur. Preserve our environment by recycling Li-Ion batteries or disposing of them in
accordance with local, State and federal regulations. Do not mix old and new batteries.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum performance. Do not
use any type of solvent for cleaning and be careful not to put too much pressure on the solar
panels while cleaning.
Trouble Shooting
If your solar charged light does not come on at dusk despite observance of all the instructions,
please try the following steps:
1. Make sure that the solar lamp is not being affected by any other light source.
2. Ensure the solar lamp is not positioned in the shade during the day.
3. Make sure the switch in the lamp head is on Bright White or Warm white position.
4. Check that the batteries are installed correctly.
NOTE: The performance of the solar lamp will vary with the time of year. It will deliver more light
when it has had a full day in the sun rather than a day in overcast weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the batteries much
more efficiently.
WARNING: Please keep out of reach of children.
Fig. 3