Gama Sonic IMPERIAL III GS-97K Series User manual

IMPERIAL III SOLAR LAMP
Models: GS-97K
GS-97K-F
GS-97K-W
GS-97K-F2
GS-97K-F3
Version 1.1
US Patent # 7172307
Instruction Manual

Solar Lamp Pre-Installation Guidelines
1. For optimum light duration throughout the night, it is very
important to mount your solar light in a spot where it receives
maximum amount of sunlight throughout the day. 4-5 hours of
direct sun exposure is the ideal condition.
2. It may take couple of days for the light to be charged and work
properly.
3. If you are replacing an existing gas/electric post light, you
must consult a certified technician to cancel them before
installation.
Fig. 1
Operation Instructions
1. Detach the upper portion of the lamp as shown in Fig. 1 by turning it
counterclockwise.
2. Turn operation switch “ON” to your desired brightness level (see Fig. 2.)
 • LOW - Lasts longer using dimmer light.
 • HIGH - Brighter light output.
3. Choose your desired LED color temperature
 • COOL – Bright White (6000K)
 • WARM – Warm White (2700K)
4. Reassemble the upper portion of the lamp by placing it on top
of the 4 hinges, and then turn it clockwise. (Fig. 3.)
IMPERIAL III SOLAR LAMP
page 2
Thank you for your purchase. GAMA SONIC
®
solar charged lighting eliminates the problems
associated with most solar lighting available today. GAMA SONIC
®
solar charged lights are
brighter and last all night with a full day solar charge. With unique designs, superior light
output and numerous installation options confirm the outstanding value of our product.
GAMA SONIC
®
has been recognized as a worldwide leader in the lighting industry for over
20 years. The company also offers unique multi-purpose rechargeable products that range
from party lights to emergency lighting products.
For technical assistance and more information call our Toll-Free number:
800-835-4113 (only within the US)
Or
visit our website or download the latest version of your instruction manual:
www.gamasonic.com Or www.gamasonic.com/user-guides
Please read the instruction manual carefully to obtain the best results from your purchase.
Fig. 2
OPERATION SWITCH
OPEN CLOSE
Fig. 3

page 3
Place Lamp Part (A) on top of your existing
3” round post and tighten the 3 screws
provided to secure the lamp.
1. First remove screws from center
support (C) and the screw from the
back of the arm (B).
2. Attach arm(s) using these screws; the
silver screw will need to be attached
from the inside of the center support
(C).
3. Place center support (C) on top of your
existing pole and tighten screws (H).
4. Place lamps (A) onto the arms and
secure with screws (F).
NOTE: locate your solar lamp facing the south
for best results.
1. Use electric drill to make two holes in the
wall
2. Place provided screw anchors into the holes
3. Place the wall bracket (N) in line with the
holes and screw on with the provided
screws.
4. Place Lamp (A) onto bracket and secure
with the 3 screws provided.
GS-97K-F
GS-97K-F2/GS-97K-F3
GS-97K-W
Assembly Instructions
A

page 4
Replacing the Batteries
Replacement batteries are available
at www.gamasonic.com or via our Toll free number: [phone]
Approximately after 2 ½ -3 years, the batteries will need to be replaced.
1. Detach the upper part of the lamp as shown in Fig. 1 (page 2) by turning it counterclockwise.
2. Make sure the operation switch is in the OFF position.
3. Release the battery compartment screws located on the silver reflector and remove the
old battery packs as shown in Fig. 4. Make sure new batteries are (3.2V/3000mAh) Li-Ion
Rechargeable Gama Sonic Batteries.
4. Install the new batteries into the battery compartment.
5. Reassemble the unit by reversing the above procedure.
WARNING: Do not dispose of Li-Ion batteries in the regular trash,
municipal waste stream or by fire as batteries may leak or explode.
Do not open, short circuit, or mutilate batteries as injury may occur.
Preserve our environment by recycling Li-Ion batteries or disposing
of them in accordance with local, State and federal regulations. Do
not mix old and new batteries.
Maintenance
Clean the solar module regularly with a damp towel to guarantee
optimum performance of the solar panel. Do not use any type of
solvent for cleaning and be careful not to put too much pressure
on the module while cleaning.
Trouble Shooting
If your solar charged light does not come on at dusk despite
observance of all the instructions, please try the following steps:
1. Make sure that the solar light is not being affected by
any other light source (i.e street lights).
2. Ensure the solar light is not positioned in the shade during the day.
3. Make sure the switch in the lamp head is in the” ON” position.
4. Check that the batteries are installed correctly.
NOTE: The performance of the solar light will vary with the time of year. It will deliver longer
duration when it has had a full day in the sun rather than a day in overcast weather.
WINTERTIME TIPS: Keep snow and debris cleaned off the solar panels so the batteries can
recharge. If the lights are covered with snow for an extended period of time, after the snow
melts, allow all the batteries to charge in full, direct sunlight for at least 6 hours to their
maximum capacity.
WARNING: Please keep out of reach of children.
Fig. 4