Garmin Forerunner 40 User manual

FORERUNNER®4 0 5
quick reference guide
GPS-ENABLED SPORTS WATCH WITH WIRELESS SYNC

2 Forerunner 405 Quick Reference Guide
Using the Touch
Bezel
The silver bezel around the watch
face acts as a multifunction button.
Tap: quickly press your nger on the
bezel to make a selection, toggle a
menu option, or change pages.
Touch and hold:hold your nger on
one of the four labeled areas on the
bezel to switch modes.
Double press: press two ngers on
two areas on the bezel to turn on the
backlight.
Touch and drag (scroll): press your
nger on the bezel and drag it around
the bezel to scroll through the menu
options or to increase or decrease
values.
WARNING: This product contains a non-replaceable lithium-ion battery.
See the Important Safety and Product Information guide in the product box
for important battery safety information.
WARNING: Always consult your physician before you begin or modify any
exercise program. See the Important Safety and Product Information guide
in the product box for product warnings and other important information.

Forerunner 405 Quick Reference Guide 3
Touch Bezel Areas
and Buttons
t
e
s
a
r
l
e
p
/
/
ti
e
m
d
at
e
➊
➋
➏
➍
➌
➎
➊
time/date: touch and hold to
enter time/date mode.
➋
GPS:touch and hold to enter
GPS mode.
➌
menu:touch and hold to open
the menu page.
➍
training:touch and hold to enter
training mode.
➎
start/stop/enter:
Press to start/stop the timer in
training mode.
Press to make a selection.
Press to exit power save mode.
➏
lap/reset/quit:
Press to create a new lap in
training mode.
Press and hold to reset the timer
in training mode.
Press to exit a menu or page.
Press to exit power save mode.
•
•
•
•
•
•
•

4 Forerunner 405 Quick Reference Guide
Bezel Tips
Touch the bezel rmly.
Touch the bezel on the outer ring,
where the words appear, not the
inner ring near the watch face.
Make each bezel selection a
separate action.
Do not rest your nger or thumb
on the bezel while using it.
Do not wear thick gloves while
using the bezel.
If bezel is wet, wipe the bezel dry
before using it.
Locking the Bezel
To prevent accidental bezel taps,
press enter and quit simultaneously.
To unlock the bezel, press enter and
quit simultaneously again.
•
•
•
•
•
•
Step 1: Charge the
Battery
Your Forerunner ships with the
power off to conserve the battery.
Charge the Forerunner for at least
three hours before using it.
NOTE: To prevent corrosion,
thoroughly dry the charging
contacts and surrounding area
before charging.
TIP: The Forerunner will
not charge when outside
the temperature range of
32°F–122°F (0°C–50°C).
To charge the Forerunner:
1. Plug the USB connector on the
charging clip cable into the AC
adapter.
2. Plug the AC adapter into a
standard wall outlet.

Forerunner 405 Quick Reference Guide 5
3. Align the charging clip posts with
the contacts on the back of the
Forerunner.
N9
Ì Ï 02
F o r e r u n ne r
40 5
12345678
FCC ID:IPH-01253
IC: 1792A-01253
Designed in the USA
Made in Taiwan
Contacts
4. Clip the charger securely over the
face of the Forerunner.
t
e
s
a
r
l
e
p
/
/
ti
e
m
d
at
e
Charging
clip
The length of time a fully charged
battery will last depends upon usage.
A fully charged battery can run the
Forerunner with GPS on for up to 8
hours. See the owner’s manual for
more information.
Step 2: Congure
Your Forerunner
The rst time you use your
Forerunner, follow the on-screen
instructions to learn how to use the
bezel and congure the Forerunner.
If you are using an ANT+Sport™
heart rate monitor, select Yes during
the conguration to allow the heart
rate monitor to pair (connect) with
your Forerunner. See Step 3 on the
next page for more information.

6 Forerunner 405 Quick Reference Guide
Step 3: Pair the
Heart Rate Monitor
(Optional)
While you are trying to pair your
heart rate monitor with your
Forerunner for the rst time, move
away (10 m) from other ANT+Sport
accessories.
The heart rate monitor is on standby
and ready to send data. Wear the
heart rate monitor directly on your
skin, just below your breastplate.
It should be snug enough to stay in
place during your run.
1. Push one tab on the strap through
the slot in the heart rate monitor.
Press the tab down.
2. Wet both sensors on the back of
the heart rate monitor to create a
strong connection between your
chest and the transmitter.
3. Wrap the strap around your chest
and attach it to the other side of
the heart rate monitor.
Heart Rate Monitor (Back)
Sensors
Tab
Heart Rate Monitor Strap
Heart Rate Monitor (Front)
Slot

Forerunner 405 Quick Reference Guide 7
NOTE: The Garmin logo
should be right-side up.
4. Press quit or enter to exit power
save mode.
5. Bring the Forerunner within range
(3 m) of the heart rate monitor.
The heart rate icon appears
on the training mode pages.
Step 4: Acquire
Satellite Signals
To set the correct time of day and
begin using the Forerunner, you must
acquire GPS satellite signals. It may
take a few minutes to acquire signals.
NOTE: To turn off the
GPS receiver and use the
Forerunner indoors, touch and
hold GPS. Select Off for GPS.
NOTE: You cannot acquire
satellites in power save mode.
To exit power save mode,
press enter or quit.
1. Go outdoors to an open area. For
the best reception, make sure
the antenna of the Forerunner is
oriented toward the sky.
t
e
s
a
r
l
e
p
/
/
ti
e
m
d
at
e
Antenna
location
2. Touch and hold training to enter
training mode.
3. Stand still and do not begin
moving until the locating satellites
page disappears.
When you are receiving satellite
signals, the GPS icon appears in
the training mode pages.

8 Forerunner 405 Quick Reference Guide
Step 5: Go for a Run!
TIP: Set your user prole so
the Forerunner can calculate
calories correctly. Touch and
hold menu > select Settings >
User Prole.
1. Touch and hold training.
2. Press start to start the timer.
3. After completing your run, press
stop.
4. Press and hold reset to save your
run data and reset the timer.
Step 6: Download
Free Software
ANT Agent™allows you to use your
Forerunner with Garmin Connect, a
Web-based training tool, and Garmin
Training Center, a computer-based
training tool.
1. Go to www.garmin.com
/forerunner405.
2. Follow the on-screen instructions
to download and install ANT
Agent.
Step 7: Pair Your
Computer and
Forerunner
NOTE: Before connecting
the USB ANT™stick to your
computer, you must download
software as instructed in Step
5 so that the necessary USB
drivers are installed.
1. Plug the USB ANT stick into
an available USB port on your
computer.

Forerunner 405 Quick Reference Guide 9
2. Bring your Forerunner within
range (3 m) of your computer.
3. WhentheANTAgentndsyour
Forerunner, ANT Agent displays
a unique number and asks you if
you want to pair. Select yes.
4. Your Forerunner should display
the same number ANT Agent
displayed. If so, select yes on
your Forerunner to complete
pairing process.
Step 8: Transfer Data
to Your Computer
Bring your Forerunner within
range (3 m) of your computer.
ANT Agent automatically transfers
data between your Forerunner and
Garmin Connect. This may take a
few minutes. Use Garmin Connect to
view and analyze your data.
Power Save Mode
After a period of inactivity, the
Forerunner switches to power save
mode. While in power save mode,
you can view the time of day,
turn on the backlight, and use the
ANT+Sport computer connection.
To exit power save mode, press the
enter or quit button.

10 Forerunner 405 Quick Reference Guide
Using the Four
Modes
Touch and hold your nger on one of
the four labeled areas on the bezel to
switch modes.
Time/date Mode
Time/date mode displays the current
time and date. Tap the bezel to scroll
through the available pages, such as
time, battery gauge, and alarm time.
GPS Mode
GPS mode allows you to view and
use the GPS menu. You can view the
satellites page, turn on and off GPS,
save and go to locations, and route
back to your starting point.
Menu Mode
Menu mode allows you to access
your Forerunner’s history, the
training menu, and the unit settings.
Training Mode
Training mode is the mode you will
use most often. Use training mode to
record your activities, view training
data, and compete with your Virtual
Partner.