GE 20765 User manual

User Manual
Customer Assistance

Safety Rules
1.
2.
4. CAUTION:
5.
6.
7.
8.
9.
10.
11.
3. WARNING:
Read and Save These Instructions
WARNING: To reduce the risk
of personal injury, do not bend
the blade arms (also referred
to as flanges), when installing
the brackets, balancing the
blades or cleaning the fan. Do
not insert foreign objects in-
between rotating fan blades.
WARNING: To reduce the risk of
fire, electric shock or personal
injury, mount to outlet box
marked “acceptable for fan
support of 15.9 kg (35 lb.) or
less” and use mounting screws
provided with the outlet box.
Most outlet boxes commonly
used for the support of light
fixtures are not acceptable for
fan support and may need to be
replaced. Due to the complexity
of the installation of this fan, a
qualified licensed electrician is
strongly recommended.
WARNING: To reduce the risk of
re, electric shock or personal
injury, mount fan to outlet box
marked acceptable for fan
support with the screws
provided with the outlet box.

Hardware Included
ATTENTION:

Package Contents
ATTENTION:
Q
Q

Fan Installation Drawing
WARNING: Review important safety instructions before installation.
9-
9-

Fan Installation
MOUNTING OPTIONS
Downrod Mount : Angle Mount :
Flush Mount :
2.13 m (7 ft.)
76 cm
(30 in.)
A
DD
BB
INSTALLING THE MOUNTING BRACKET
DANGER: A loose outlet box can cause the fan to
wobble and increase the fan’s potential to fall,
which could result in serious injury or death.
Note:
WARNING: Do not use an existing mounting bracket
in the outlet box, replace it with the new mounting
bracket that is included with the fan.

Fan Installation
* For Downrod/Angle Mount assembly, proceed to following steps.
O
O
N
F
M
N
B
FN
5.
MC
D
E
* For Flush Mount assembly, skip to Step 8 to 10 on page 10.
HANGING THE FAN
2.
4.
3.
1.
6.
WARNING: Failure to properly install cotter pin
could result in fan loosening and possibly falling.
WARNING: Install canopy (C) on the downrod with
the two keyhole slots facing up toward the ceiling.
B
B

D
Put the canopy cover ring (D) onto the motor housing.

*
*
*Note: Not applicable for flush mount installation as downrod
assembly (B) is not used.
downrod assembly (B)

Fan Installation
C
L
C
D
C
F
K
FF
EE
K
J
L
A
A
Downrod/Angle Mount
Flush Mount
Flush Mount
D
C
FINISHINGTHEFANINSTALLATION
1. 2.
Downrod/Angle Mount
Note:
ATTACHING THE FAN BLADES

Fan Installation
H
G
G
I
PQ
G
F
INSTALLINGTHELIGHTKIT
Note: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not sufficient to prevent electric shock.
Note:

REMOTE FUNCTIONS

Safety Instructions
PRODUCT MAINTENANCE WARNING: Make sure the power is
off at the electrical panel box before
you attempt any repairs. Refer
to the section “Making Electrical
Connections”
TROUBLESHOOTING
PROBLEM SOLUTION
Fan will not start
Fan sounds noisy
LED will not light
Remote control
V2.20180411