
WARNING: To avoid eye injury, do not stare directly into the light beam or shine the
beam directly into anyone’s eyes. This product is not designed, intended, or
recommended for children or hazardous environments.
CAUTION: The flashlight may become warm or hot after extended periods of use
at the highest setting. Select a lower setting when the flashlight is hot. This is
typical for high-powered flashlights and does not cause damage to the flashlight.
WARNING: Lithium-ion batteries can present a fire, explosion, and burn hazard. Use
only 18650 battery cells with a protection circuit produced by Panasonic, Sanyo, Sony,
Samsung, or LG. Remove the battery when the flashlight is not in use. The use of
other cell manufacturers or the failure to follow the battery manufacturer's safety
instructions may result in fire, explosion, personal injury, and damage to property.
WARNING: Always follow the battery manufacturer’s instructions as to the proper
usage, handling, storage, and disposal of batteries. Use only batteries from a
reputable manufacturer. Do not mix dierent brands or types of batteries in the
same flashlight. Replace all batteries at the same time. Failure to follow safety
instructions may result in personal injury and damage to property.
AAA Battery Installation
1. Unfasten the tail cap and remove the
battery holder.
2. Insert 3 AAA batteries following the
correct polarity (+,-) marked on the
battery holder.
3. Insert the battery holder back into the
flashlight with the positive (+) end first.
On/O
Zoom
1. Hold both ends of the flashlight; gently
twist and pull each end away from the other.
2. Pull the two ends away from each other
to zoom in and push the two ends together
to zoom out.
To turn the flashlight on, press down firmly on the red power button located
on the tail of the flashlight until you hear a click.
To turn the flashlight o, press down firmly again until you hear a click.
18650 3.7V Lithium-ion Rechargeable Battery Installation (See Warning)
1. Insert one 18650 battery (Fig. 1) inside the 18650 clear battery tube (Fig. 2).
2. Insert the combined 18650 battery and clear tube into the flashlight with the
positive (+) end first.
Switching Modes
There are 3 dierent lighting modes. (High, Medium, Low)
To switch through the dierent lighting modes, gently press down on the red
power button to alternate through the 3 modes.
The flashlight will switch to the next mode when turned o and on in quick
succession. It will reset back to the highest mode after being o for more than
10 seconds.
GETTING STARTED
OPERATIONS
CONVEX LENS
ZOOMABLE
DESIGN
RUBBER
O-RING
AAA
BATTERY
HOLDER
TAIL CAP
WARNING: Remove the batteries if the flashlight is not working properly. Failure
to do so may result in personal injury and damage to property.
POSITIVENEGATIVE
LANYARD
Fig. 1 Fig. 2
18650
RECHARGEABLE
LITHIUM-ION BATTERY
HIGH
MEDIUM
LOW
POSITIVENEGATIVE