Gear Light X1000 User manual

X1000 LED TACTICAL FLASHLIGHT
Operation Guide
TROUBLESHOOTING
If the flashlight does not turn on, or works intermittently:
Replace the batteries.
Make sure the tail cap is twisted on tightly and batteries are inserted correctly.
If the flashlight flickers or changes modes automatically:
Make sure the tail cap is twisted on tightly.
If light appears dim or faded:
Irvine, California | USA | www.GearLight.com
WARRANTY AND LIMITATION OF LIABILITY
MAINTENANCE
Inspect the flashlight monthly and carefully remove any damaged batteries and clean
any corrosion. If the flashlight is used less than once a month, remove the batteries
between uses. Lubricate all threads and rubber O-rings with petroleum jelly twice
yearly.
Limited One-Year Warranty
GearLight warrants this product for one year from the date of purchase
against any defects in material or workmanship. This warranty does not cover
normal wear and tear, nor damage resulting from misuse or neglect. We will,
at our discretion, repair, replace, or refund the purchase price of this product
should we determine it to be defective.
Limitation Of Liability
Liability limited to the purchase price of this product. GearLight shall not be
liable for any incidental or consequential damages or any implied warranty on
this product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
If problem persists: LED Failure. Contact GearLight for replacement.
Replace the batteries.
2x GearLight X1000 LED Tactical Flashlights
2x 18650 Clear Battery Tubes (Inside Flashlights)
2x AAA Battery Holders (Inside Flashlights)
2x Lanyards
1x Operation Guide
1x Warranty Card
Package Contents:
IMPORTANT SAFETY NOTICE: Lithium-ion batteries are potentially hazardous and can present a
fire, explosion, and burn hazard. By using lithium-ion batteries, you agree that GearLight shall not
be liable for any incidental or consequential damages arising from, relating to or connected with the
use of lithium-ion batteries. If you do not agree with these conditions, please use only alkaline or
NiMH rechargeable batteries.
FOR YOUR SAFETY, READ BEFORE OPERATING
V3

WARNING:To avoid eye injury, do not stare directly into the light beam or shine
the beam directly into anyone’s eyes.
CAUTION: The flashlight may become warm or hot after extended periods of use
at the highest setting. Select a lower setting when the flashlight is hot. This is
typical for high-powered flashlights and does not cause damage to the flashlight.
AAA Battery Installation
1. Unfasten tail cap and remove battery holder and clear tube.
2. Insert 3 AAA batteries following the correct polarity (+,-) marked on the battery
holder.
3. Insert the battery holder inside the clear tube.
4. Place the combined battery holder
and clear tube back into the flashlight
with the positive (+) end first.
On/O
Zoom
1. Hold both ends of the flashlight; gently twist and pull each end away from the
other.
2. Pull the two ends away from each other to zoom in and push the two ends
together to zoom out.
To turn the flashlight on, press down firmly on the red power button located
on the tail of the flashlight until you hear a click.
To turn the flashlight o, press down firmly again until you hear a click.
18650 Lithium-ion Rechargeable Battery Installation (See Warning)
1. Insert one 18650 battery inside the clear tube.
2. Place the combined 18650 battery and
clear tube into the flashlight with the
positive (+) end first.
Switching Modes
There are 5 dierent lighting modes. (High, Medium, Low, Strobe, SOS)
To switch through the dierent lighting modes, gently press down on the red
power button to alternate through the 5 modes.
The flashlight will switch to the next mode when turned o and on in quick
succession. It will reset back to the highest mode after being o for more than
10 seconds.
GETTING STARTED
OPERATION
WARNING: Always follow the battery manufacturer’s instructions as to the proper
usage, handling, storage, and disposal of batteries. Use only batteries from a
reputable manufacturer. Do not mix dierent brands or types of batteries in the same
flashlight. Replace all batteries at the same time. Failure to follow safety instructions
may result in personal injury and damage to property.
WARNING: Lithium-ion batteries can present a fire, explosion, and burn hazard. Use
only 18650 battery cells with a protection circuit produced by Panasonic, Sanyo, Sony,
Samsung, or LG. Remove the battery when the flashlight is not in use. The use of
other cell manufacturers or the failure to follow the battery manufacturer's safety
instructions may result in fire, explosion, personal injury, and damage to property.