Genie Wireless Keypad User manual

1
Keypad
Up/Down Key
(enter)
Program Key
LED
LED Off
LED On
LED Flashing
Keypad Off Keypad On Keypad Flashing
WARNING
A moving door can cause serious injury or death.
DO NOT
.
WARNING
If Safety Reverse does not work properly:
DO NOT
Door and Door Opener Owner’s Manuals
Wireless Keypad Instructions
FOR YOUR CONVENIENCE—IT'S EASIER TO PERFORM PROGRAMMING BEFORE
MOUNTING KEYPAD.
Keypad LED's
yrtnEdeliaFseirtnElufsseccuS
Preparation for Use
ALL
Up/Down key
Program key
Program key
ALL
Green
HOLD
Red
Keypad Overview
®
38318501760

2
Setting Up a PIN
Program key
Program key
For multiple doors only
Program key
Program key
Up/Down Key
Program key
Program key
Programming
Locate Your Opener’s Programming Buttons and LED
New Genie Openers
Other New Model Genie Openers:
Synchronizing Keypad to Opener
Program Set key
NOTE:The Learn Code button and LED may be located under the light lens
or you may have to remove your unit's cover.
or
Green Red
HOLD
RADIO
SIGNAL
LEARN
CODE CODE
LEARN
SET
SET
OPEN
FORCE
CLOSECODE
LEARN LIMITMANUAL
or
PROGRAM
SET – +
PROGRAM
SET – +
PROGRAM
SET – +
HOLD 2 seconds
RADIO
SIGNAL
LEARN
CODE
RADIO
SIGNAL
LEARN
CODE

3
Up/Down key
Up/Down key
Up/Down key
NOTE:Pressing any key will stop or start the opener while the door is in
motion. The door will automatically stop fully open or closed. When the
door has stopped moving, pressing on any single button will activate door
until backlight goes off (30 seconds).
NOTE:Rapid blinking of the red LED on the Powerhead indicates an error.
When the blinking stops, you must start programming steps over.
For multiple doors only
Up/Down key
Up/Down key
Up/Down key
MUST MUST
NOTE:Pressing any key will stop or start the opener while the door is in
motion. The door will automatically stop fully open or closed. When the
door has stopped moving, pressing on any single button will activate door
until backlight goes off (30 seconds).
NOTE:Rapid blinking of the red LED on the Powerhead indicates an error.
When the blinking stops, you must start programming steps over.
Using The Keypad
Up/Down key
For multiple doors only
Up/Down key
Mounting Keypad
The keypad MUST be mounted within sight of the garage door(s)
at least 5 feet above the floor and clear of any moving door part.
(Continued other side)
OpenerOpener
Opener
Opener
or or
Opener
or or
Wall
1/8"
Screw
head gap

4
Mounting Keypad
DO NOT
Resetting PIN
If you have forgotten your PIN or you fear it may have fallen into
unauthorized hands, you must erase the old programming.
Program key Up/Down key
"Setting Up a Pin"
"Programming"
Changing Your PIN
Program key
Program key
Temporary PIN
Program key
Program key
NOTE:The temporary PIN is automatically cancelled whenever you
enter your normal PIN after the temporary PIN is set.
Replacing Batteries
HOLD HOLD
Additional Genie®products can be ordered through your local GENIE®Professional Dealer. To locate a dealer near you–call 800-OK-GENIE.
If the first five digits of your serial number fall between 10289 and 11188 contact Genie for assistance 800-354-3643.
FCC and IC CERTIFIED