Gevi CM7015-NM User manual

ESPRESSO MAKER
INSTRUCTION MANUAL
CM7015-NM

IMPORTANT SAFEGUARDS
Dear Gevi customer
Gevi have focused on creating perfect home appliance
for our customer. In the past years, it took us time, lots
of research and many prototypes to achieve our goal.
We would like to give you a different using experience.
Thanks for purchasing our Gevi products, you could
search from our official website, to learn more products
information.
When using electrical appliances, basic safety precautions should
always be followed to reduce the risk of fire, electric shock,
and/or injury to persons,including the following:
Read all instructions.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory, or
mental capabilities,or lack of experience and knowledge,
unless they are closely supervised and instructed
concerning use of the appliance by a person responsible
for their safety.
Close supervision is necessary when any appliance is
used by or near children. Children should be supervised
to ensure that they do not play with the appliance.
Do not touch hot surfaces. Use handles or knobs. Care
must be taken as burns can occur from touching hot parts
or from spilled, hot liquid.
To protect against electric shock, do not place cord, plug,
or espresso maker in water or other liquid.
Unplug from outlet when the espresso maker is not in use
and before cleaning. Allow to cool before putting on or
taking off parts and before cleaning the appliance.
Espresso maker must be operated on a flat surface away
1.
2.
3.
4.
5.
6.
7.

OTHER CONSUMER SAFETY INFORMATION
This appliance is intended for household use only.
SAVE THESE INSTRUCTIONS
from the edge of counter to prevent accidental tipping.
Do not operate any appliance with a damaged supply
cord or plug, or after the appliance malfunctions or has
been dropped or damaged in any manner. Supply cord
replacement and repairs must be conducted by the
manufacturer, its service agent, or similarly qualified
persons in order to avoid a hazard. Call the provided
customer service number for information on
examination, repair, or adjustment.
The use of accessory attachments not recommended by
the appliance manufacturer may result in fire, electrical
shock, or personal injury.
Do not use outdoors.
Do not let cord hang over edge of table or counter or
touch hot surfaces, including stove.
Do not place espresso maker on or near a hot gas or
electric burner or in a heated oven.
To disconnect espresso maker, turn controls to OFF ( )
and then remove plug from wall outlet.
WARNING! To reduce the risk of fire or electric shock, do
not remove the bottom cover. No user-serviceable parts
are inside. Repair should be done by authorized service
personnel only.
8.
9.
10.
11.
12.
13.
14.
Do not use appliance for other than intended use.15.
WARNING Electrical Shock Hazard:
This appliance is provided with a polarized plug (one wide
blade) to reduce the risk of electric shock. The plug fits only
one way into a polarized outlet. Do not defeat the safety
purpose of the plug by modifying the plug in any way or by
using an adapter. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, have an electrician
replace the outlet.
The length of the cord used on this appliance was selected
to reduce the hazards of becoming tangled in or tripping
over a longer cord. If a longer cord is necessary, an
approved extension cord may be used. The electrical rating
of the extension cord must be equal to or greater than the
rating of the appliance. Care must be taken to arrange the
extension cord so that it will not drape over the countertop
or tabletop where it can be pulled on by children or

accidentally tripped over.
To avoid an electrical circuit overload, do not use another
highwattage appliance on the same circuit with this
appliance.
Electrical parameters: 120V~ 60Hz 1050W
BEFORE FIRST USE: Wash all removable parts in hot, soapy
water. Rinse and dry. Brew one cycle and discard water.
NOTE: The unit may produce a pumping sound when a cup
size has been selected. This is normal. The sound tells you
that water is pumped for brewing espresso.
NOTES:
• Only use Nespresso and other compatible
espresso capsules.
• During brewing, never lift the handle.
Otherwise the espresso capsule will be
expelled into the used capsule container.
HOW TO MAKE ESPRESSO
PARTS AND FEATURES
Cup Rest With Drip Tray
Removable Water
Reservoir With Lid
Base
Handle
Capsule Holder
Used Capsule Container
Power Switch
Espresso Dispenser
Lungo Cup Button
Espresso Cup Button
1. Fill removable water reservoir
with water. Do not exceed the
MAX fill line.
2. Place a cup on the cup rest
with drip tray.
3. Plug into outlet.
4. Press the power switch to the
ON (I) position. Both espresso
and lungo cup buttons will
start to flash.
5. Lift the handle after both cup
buttons stop flashing.
6. Insert an espresso capsule
according to the cutout on the
top of the unit.
7. Push down handle.

NOTE: Approximate quantity can be adjusted between 20 and
70 ml for espresso and between 70 and 120 ml for lungo.
NOTES:
• Press espresso or lungo button at any time to stop the brewing process. Empty
cup and follow directions on page 4 to start a new brew cycle.
• Always use cold water to make espresso. Warm water or other liquids could cause
damage to the appliance.
• Never open the handle during brewing cycles.
HOW TO ADJUST ESPRESSO QUANTITY
8. Press the desired cup size
button.
9. The desired cup size will flash
when espresso is brewing.
10. When espresso stops
brewing, the cup light stops
flashing.
11. Lift up the handle to expel
the used espresso capsule
automatically into the used
capsule container.
12. Press the power switch to the
OFF ( ) position. Unplug.
1. Press and hold espresso
or lungo cup button for 3
seconds. The indicator light
will flash.
2. Release button.
3. Press selected cup button
again to start the brewing
process.
4. Press button to stop brewing,
and the espresso maker will
keep this quantity in memory.
NOTE: To restore the factory
settings, hold down both
buttons until they flash twice
(about 3 seconds).

RECIPES CARE AND CLEANING
Espresso/Lungo
Cappuccino
Latte
Iced espresso,
cappuccino, or
latte
Mocha
Brew one cup at a time following directions.
Optional: Add sugar to taste.
Mix 1/3 espresso, 1/3 steamed milk, and 1/3 frothed milk.
Top with ground nutmeg, ground cinnamon, powdered
chocolate or vanilla to taste.
Mix 1/2 espresso with 1/2 steamed milk.
Top with ground nutmeg, ground cinnamon,
powdered chocolate or vanilla to taste.
Mix beverage as described above; then pour
over ice.
Mix 1 ounce thick chocolate syrup with 1/3
espresso. Fill with frothed or steamed milk.
1. Lift up the handle to expel
the used espresso capsule.
Empty the used capsule
container.
2. Follow package directions for
descaler liquid, filling to MAX
fill line.
3. Place a cup on the cup rest.
4. Plug into outlet.5. Press the power switch to the
ON (I) position. Never open
the handle during brewing
cycles.
6. Once the buttons stop
flashing, press the lungo
button and the liquid will flow.
7. After the brew cycle stops, wait 20 minutes with the machine
turned on. Brew all of the descaling liquid, emptying the cup after
each brew cycle. Remove water reservoir, rinse, and fill with clean
water. Brew until all water has been used.

8. Press the power switch to the
OFF ( ) position.
9. Unplug. 10. Carefully wipe base and cord
with a damp cloth or sponge.
Dry. Wash all removable parts
with hot, soapy water. Rinse
and dry.
TROUBLESHOOTING
• Check that the plug has been inserted correctly into the
outlet and that the power switch is in the ON (I) position.
• Espresso maker is in power-saving mode. Press espresso or
lungo button.
PROBLEM
No power.
Espresso is not
dispensing.
There is water
at the bottom
of the machine.
The capsule
cannot be
placed into
capsule holder.
The capsule cannot
drop into the used
capsule container
normally.
A slight hiss can
be heard after the
espresso has been
dispensed.
Espresso drips from
the espresso
dispenser
after brewing is
completed.
Cup lights are
flashing.
PROBABLE CAUSE/SOLUTION
• The capsule inserted may be faulty. Try again with a new
capsule.
• No water in the water reservoir. Fill water reservoir with clean
water.
• Unit is preheating. Wait for the espresso and lungo buttons to
turn solid.
• Make sure that the reservoir has been placed correctly into
position.
• Check if the used capsule container is full and needs to be
emptied. The handle may not have opened correctly.
Try opening handle again.
• Check if the used capsule container is full and needs to be
emptied. The handle may not have opened correctly.
Try opening handle again.
• This is a function of the espresso maker which is normal.
• This is normal and the dripping will stop. Keep the cup on the
cup rest until dripping stops.
• Water reservoir is empty or reservoir is not securely in place.
Add water to water reservoir. Place water reservoir
securely in base.
• Espresso maker needs to be descaled. See Care and Cleaning
on page 7.