AUTOMATIC START FUNCTION
7.
8.
9.
10.
The brewing process can be interrupted by pressing the
POWER button once at any time during operation. The
appliance will continue brewing once POWER is pressed
again.
Note: You can take out the jug, pour and serve at any time.
The appliance will stop dripping automatically. But the
time cannot exceed 30 seconds.
Remove out carafe to serve when finish brewing (about
one minute later after the coffee stops dripping out.)
Note: the coffee you get will less than the water you have
added, as some water is absorbed by coffee ground.
When the process is finished, if you do not want to serve
immediately, keep the coffee maker is energized, the
coffee can be kept warm in the keeping warm plate. The
appliance will be cut off power automatically after 2 hour
if it has not been manually disconnected at the
completion of brewing. For an optimum coffee taste,
serve it just after brewing.
Always turn the coffee maker off and disconnect the
power supply when not use.
Caution: When pour coffee, the momentary inclined angle
of carafe shall not be more than 45 degree from the
vertical position, you shall pour the coffee slowly until the
carafe is empty, otherwise the coffee in the carafe will
rush to the bottom of carafe lid, and the coffee will flow
out from two edges of lid and hurt person!
If you do not want the coffee maker to start operation immedi-
ately, for example now it is 5:10 pm, you hope that the coffee
maker will automatically start at 8:15 in the evening, first
follow steps 1 to 5 of above section, then you can set the auto-
matic start function as follows:
1.
2.
Press BREW or WARM button for more
than 5s, the current delayed time is
showed on display.
Press the BREW and WARM button
continuously to set the present time
(real clock), that is 17:10 (See fig. 1).
Note: the time cycle is 24 hours.
