Geyser ECO User manual

I N STA LL AT I ON A N D O PE R ATI O N
MANuAL

Thank you for buying Geyser water lter!
Our developments and technologies make it possible to ensure the excellent water quality
in your house.
This manual describes all of the functions and installation procedure of Geyser water
ltering system. Please carefully read and keep it for future use.
The water lter set includes all required parts to use the system immediately after
installation.

CONFIRMED BY TESTS:
Anti-plague station medical unit No. 164 of Federal medico-biological Agency of Russia
(accredited testing laboratory center Rostest)
FSBI “SRI of Influenza” Ministry of healthcare of Russia
FSBI ECH and STATE them. Sysina, The Health Ministry of Russia
TECHNICAL CHARACTERISTICS OF
GEYSER-ECO FILTERS
Cartridge Aragon 3 Eco
Temperature of ltered water: °С +4...+40
Maximum operating pressure, atm 7
Capacity, l/min up to 3,6
Housing material stainless steel
Height/diameter, mm 225/171
Cartridge service life*, l up to 12000
*The actual service life depends on contamination degree of the source water
FILTERING EFFECTIVENESS OF
ARAGON-3 ECO FILTER
Particles of > 0.1 µm in size up to 99%
Lead, zinc, cadmium, cesium up to 95%
Chlorine up to 100%
Pesticides up to 92%
Iron up to 95%
Aluminium up to 97%
Oil products up to 90%
SCOpO OF SuppLY
1. Filter with installed Aragon-3 ECO Cartridge...............................................................1 pc
2. Clean water faucet .........................................................................................................1 pc
3. Connector pipe, 1/4” JG .................................................................................................1 pc
4. T-piece adaptor with tap ...............................................................................................1 pc.
5. Operation Manual ..........................................................................................................1 pc
6. Packaging .......................................................................................................................1 pc
puRpOSE
The Geyser Eco lter is designed for purication of the tap water from chlorine, organic
and organochlorine substances, heavy metals, iron, petroleum, mechanical particles and other
undesirable impurities. It reduces the content of hardness salts.
The compact lter Geyer Eco includes all the traditional methods of water treatment:
mechanical ltration, ion exchange, sorption, iron removal and disinfection.
The lter is equipped with composite cartridge Aragon 3 ECO, which combines unique
properties of Aragon material and high quality coconut carbon (carbon block); this leads to
increase of sorption purication capacity from chlorine and organic matter. Despite its compact
size, Aragon-3 Eco provides high resource high efciency of water purication
FEATuRES & BENEFITS
RELIABLE AND ECO-FRIENDLY STAINLESS STEEL HOuSING
The housing is tested at pressure of 25 atm.
Clamp connection provides tightness and easy cartridge replacement.
Stainless steel housing guarantees reliability and durability.
IT IS EASY TO INSTALL AND MAINTAIN
Everything you need to connect the lter is included in the delivery set. Cartridge
replacement is made without special tools or arrangements.
COMpACT
The lter takes 3 times less space than a conventional three-stage lter.

INSTALLATION OF THE CLEAN WATER TAp
Drill a 12 mm diameter hole in the sink.
Assemble the water tap in the following sequence:
faucet
decorative washer
rubber gasket
rubber washer
plastic washer
split washer
metal nut
31
А
2
В
!
FILTER INSTALLATION
It is recommended to install the lter with assistance of a qualied expert or a representative
of the manufacturer.
Do not disassemble the equipment without need.
PLEASE NOTE! Before you begin work, shut off the water supply and reduce the pressure
by opening any faucet below the shut-off position.
SETTING up THE FILTER
The system is attached to the cold water main.
Take out the lter from the packaging. Remove transport
plugs. Press the end of the screwdriver on the plastic ring in
the connector and pull out the plug. Cut the pipe provided in the
set into two parts, and attach each of the parts to the “in” and
“out” nozzles of the lter (g. 1). Place the lter in the location
convenient for further operation. To make cartridge replacement
more convenient, leave a 15 cm clearance between the floor and
the bottom of the lter body.
CONNECTION TO THE WATER SuppLY LINE
Make sure that the water supply line is shut off!
1. Install the adapter T-piece (A) on the cold water main, and
seal the junctions (g. 1)
2. Insert the plastic pipe into the nut (B) Install the pipe fully into the nozzle of the ball valve and
tighten the nut (g. 3)
1

PLEASE NOTE! Tighten the collar clamp if there should be any leakage from under the
lid of the body.
Secure the faucet on the sink. Pass through the blue-color tube into nut (Е) (Fig. 1). Insert
piston (Z) inside the tube as far as it will go. Put plastic stop ring (L) onto the tube end (Fig. 2).
Screw the nut onto the threaded faucet rod (Fig. 3).
32
L
1
Е
Z
REpLACING CARTRIDGES
Cut off the water supply to the lter. Open clear water faucet. Disconnect the tube from lter.
Loose the clamp connection (Fig. 1) open the clamp and detach the cover from the housing (Fig. 2).
Remove the cartridge (Fig. 3). Remove the plug from the bottom part of the cartridge and
put it at the new one. Install new cartridge and put it at the lter cap. Lubricate the o-ring with
silicone grease (not sealant!) or vaseline.
Insert the cartridge with the cap into the housing and latch the clamp. Screw the clamp
connections. Supply water to the lter and make sure that there is no leakage in all connections,
rectify if required. Let the water run through the lter for 2 minutes.
123
Before starting to use the lter, wash it through for 2-5 minutes. Wash the lter through after
replacing the cartridge and after a lengthy interruption in use (more than 5 days). There’s air left
in the system after the installation of the new lter or after replacing the cartridge. This leads to
excessive water aeration (visually the water appears to be of milky white color). As the lter is
used, the air will leave the system and the cleaned water will become transparent.

WARRANTY CERTIFICATE
Release date
FILLED BY A VENDOR
Date of sale Vendor stamp
ATTENTION! In case of do-it-yourself connection, the manufacturer bears no
responsibility and accepts no claims resulted from the incorrect connection.

REpRESENTATIVE OFFICES
pRECAuTIONS DuRING TRANSpORATION AND STORAGE
Prevent the filter from falling, freezing and hitting. The filter can be transported in any enclosed
transport (except non-heated plane compartments), in accordance with corresponding mode of
transportation norms and rules.
The filter must be stored in full packaging at least 1 meter away from any heating devices at the
temperature from +5 to 25°С.
Keep away from aerosols, aggressive and fragrant substances.
WARRANTY
This lter is under warranty for three years since the date of sale; the clean water tap is under warranty
for 1 year. If there should be no date of sale and stamp of the retail organization in the warranty brochure,
its warranty period shall be calculated from the manufacturing date. This warranty shall not apply to
the cartridge, the service life of the cartridge is shown in Table 1. If any manufacturing defects should
be discovered in the cartridge, it can only be replaced after the service unit representative inspects it.
The manufacturer shall not be responsible for any operating problems or consequences of using
the lter if:
the filter or its parts has mechanical damages;
the setup and maintenance operations did not follow the instructions as set forth herein; the
cartridge is beyond its resource life;
the filter was not used for its intended purpose (to filter aggressive liquids).
The service life of lters is 10 years. Maintenance and post-warranty repairs are carried out by the
manufacturer of their regional representatives.
Manufactured in accordance with TU 3697-023-48981941-2014
MANuFACTuRER: “AKVATORIA” LTD
Registered address:
69 Shosse Revolyutsii, build. 6, lit. A,
Saint Petersburg, Russia 195279
Telephone/Fax: [phone] (multichannel)
Postal address:
195279, St. Petersburg, p/o box 379
e-mail: [e-mail]
GEYSER D.O.O.
Južni Bulevar 136
111 18 Belgrade, Srbija
Phone: +381141744 20 77
e-mail: [e-mail]
TIRAIS uDENS SIA
Salamandras iela 1, Riga, LV-1024 Latvia
Phone: [phone]
e-mail: [e-mail]
GEYSER FILTRY. S R.O.
Sokolovská 1276 / 152
180 00 PRAHA 8, Сeská republika
Phone: [phone]
e-mail: [e-mail]
www.geyser.pro
www.geizer.eu
www.geizer.com