Ghibli & Wirbel FR30 SM45 Touch Installation guide

FR30 SM45 TOUCH - RAPID30 SM45 TOUCH_ 49.0265.00
ENGLISH
PROBLEM CAUSE SOLUTION
Pressing the switch (45)
“”, the machine does not
work.
Low battery.
Main fuse blown.
The battery’s plug is still lo-
cated in the charger’s outlet.
Check that the battery is
charged.
Replace the main 50A or 75A fuse.
Place the plug correctly.
The brush does not rotate. Function card damaged.
The touch sensor on the
handle is defective.
Brush motor damaged.
Brush switch not pressed or
failure.
Replace.
Replace.
Replace.
Press the appropriate switch
or replace it.
Aspirator does not work. Function card damaged.
Intake motor damaged.
Vacuum switch not pressed
or failure.
Recovery tank full.
Replace.
Replace.
Press the appropriate switch
or replace it.
Empty, wash and clean the
tank.
The machine does not dry
well, leaving traces of water
on the floor.
Aspirator off.
Aspiration tube blocked.
Dirty wiper.
Recovery tank full.
Dirty water filter clogged.
Squeegee rubber blades
worn.
Start up the aspirator.
Check and if necessary
clean the aspiration tube that
connects the squeegee to
the recovery tank.
Clean the wiper.
Empty the recovery tank.
Clean the filter.
Replace or turn over the
squeegee rubber blades.

FR30 SM45 TOUCH - RAPID30 SM45 TOUCH_ 49.0265.00
ENGLISH
PROBLEM CAUSE SOLUTION
No water comes out. Tank empty.
Solenoid valve enabling
switch not pressed.
Tap turned off.
Filter blocked.
Solenoid valve does not
work.
Fill the tank.
Press the switch.
Open the tap
Clean the filter.
Call the technical support
service.
Insufficient floor cleaning. Unsuitable brushes or deter-
gent.
Brush worn.
Use brushes or detergents
which are suitable for the
type of floor or dirt to be
cleaned.
Replace the brush.