Ghibli & Wirbel FRECCIA 30 E 45 Installation guide

FRECCIA 30 E 45_ 49.0219.00
ENGLISH
PROBLEM CAUSE SOLUTION
Pressing the switch (34), the
machine will not turn on.
Circuit switch to position “0”.
Power cable disconnected.
Press the power switch.
Connect the cable.
The brush does not rotate. Function card damaged.
The touch sensor on the
handle is defective.
Brush motor damaged.
Brush rotation enabling
switch not pressed.
Replace.
Replace.
Replace.
Press the switch.
Aspirator does not work. Function card damaged.
Intake motor damaged.
Suction unit switch not
pressed.
Recovery tank full.
Replace.
Replace.
Press the switch.
Empty, wash and clean the
tank and the probes.
The machine does not dry
well, leaving traces of water
on the floor.
Aspirator off.
Aspiration tube blocked.
Dirty wiper.
Recovery tank full.
Dirty water filter clogged.
Squeegee rubber blades
worn.
Start up the aspirator.
Check and if necessary clean
the aspiration tube that con-
nects the squeegee to the re-
covery tank.
Clean the wiper.
Empty the recovery tank.
Clean the filter.
Replace or turn over the
squeegee rubber blades.

FRECCIA 30 E 45_ 49.0219.00
ENGLISH
PROBLEM CAUSE SOLUTION
No water comes out. Tank empty.
Solenoid valve enabling
switch not pressed.
Tap turned off.
Filter blocked.
Solenoid valve does not
work.
Fill the tank.
Press the switch.
Open the tap
Clean the filter.
Call the technical support ser-
vice.
Insufficient floor cleaning. Unsuitable brushes or deter-
gent.
Brush worn.
Use brushes or detergents
which are suitable for the type
of floor or dirt to be cleaned.
Replace the brush.