Gimenez Ganga Saxun Plisada Glass 111 Setup guide

Assembly and installation manual
Plisada Glass
MK1146 · EN · 02 · 0522
Giménez Ganga, S.L.U.
Polígono Industrial El Castillo
C/ Roma, 4
03630 • Sax (Alicante) • España
saxun.com EN
Place the frame in the window opening, without removing
the protective adhesive tape.
Warnings
Product installation
Clean the marked areas of the window with alcohol.
Then, adjust the clips to be as close as possible to the corners.
General recommendations regarding safety, use
and restrictions
In order to ensure the safe assembly, use and maintenance of this product, a
number of precautionary measures must be taken. Please observe the following
warnings and instructions, for the safety of all concerned.
Please read this manual carefully
before starting work.
Some components may be sharp or
have jagged edges. It is therefore
advisable to wear safety gloves..
All parts supplied have been designed
specically for this product. The re-
placement or addition of other parts
may have a negative eect on the
safety of the product and its warranty.
Under no circumstances should a
damaged product be installed, as
it may damage the equipment and
create situations that are dangerous
for people.
These systems are exclusively inten-
ded for the use for which they were
designed. Any other use is inappro-
priate, and therefore dangerous.
The manufacturer will not be liable
for damage caused during the ins-
tallation due to non-compliance with
these recommendations.
1
2
1
2
3
1
1
1
1. Clean the window
2. Adjust the supports
Remove the protective adhesive tape.
Press each corner rmly against the
window for 5 seconds, starting with
the lower corners of the Stor
3. Install the product
Model 140
Model 111

Insert the piece with adhesive into the piece shown, applying pressure.
2.1 Attach the interior angle to the angle.
2.2 Place the shown half of the thread clip in position.
2.3 Insert two clips into the prole groove as shown, with the same dimensions
in the two proles, equivalent to the height of the window. And one in the
remaining prole.
2.4 Place the angles at both ends and attach them to the uneven prole, using 8
normal screws and 4 left-hand screws.
3.1 Position the lateral proles, joining the previously assembled bottom prole
to the Stor box.
3.2 Attach the assembly using the left-hand screws. Screw them diagonally into
the angles.
3.3 Repeat the operation with the remaining screws.
Starting with side A
4.1 With the other half of the clip, clamp the thread
4.2 Place the clip perpendicular to the plane of the Stor. Rotate and hold the
clip as shown.
Model 111
4.3 Repeat the same process on the other side.
4.4 Fix on the upper frame with the ceiling bracket.
Model 140
4.3 Repeat the same process on the other 3 sides, tightening the thread.
1. Clip proles
2. Bottom prole 3. Product assembly 4. Thread tension
Components
Model 111
Model 140
5x Clip frame 3x Perl marco
4x Prole
frame
1x Upper prole
with ceiling support
2x Clip cuerda
4x Clip cuerda
4x Interior
antgle
Screws
8x 12x
4x Angle
Product assembly
x4 x8 Star screwdriver
Gira a izquierda
1
2
5x
4x
3
4
x4 x4 Star screwdriver
2
1
4
3
1
3
2
4
A
A
Model 140
Model 111
Turn left