Glacier bay 2190SSHD User manual

THANK YOU
We appreciate the trust and condence you have placed in Glacier Bay through the purchase of this Premium Pole Caddy.
We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products
available for your home improvement needs. Thank you for choosing Glacier Bay!
USE AND CARE GUIDE
PREMIUM POLE CADDY
Questions, problems, missing parts?
Before returning to the store, call Glacier Bay Customer Service
8 a.m. - 6 p.m., EST, Monday - Friday
1-855-HDGLACIER
HOMEDEPOT.COM
Item #892 204
Model #2190SSHD

2
Table of Contents
Safety Information
Table of Contents ...................................2
Safety Information ..................................2
Warranty ..........................................2
Pre-Installation.....................................3
Planning Installation ...............................3
Package Contents...................................4
Installation ........................................5
Care & Cleaning ....................................8
Troubleshooting ....................................8
□Read through this entire manual prior to assembly and installation.
Warranty
LIMITED LIFETIME WARRANTY
WHAT IS COVERED
The manufacturer warrants this product to be free from defects in the workmanship and materials present at the time of shipment from
the factory for a lifetime from the date of purchase by the original purchaser. The manufacturer agrees to correct such defects without
charge or at its option replace the product with a comparable or superior model.
WHAT IS NOT COVERED
All costs of removing and reinstalling the product are the purchaser’s responsibility. Any alteration of this product or use of this product
in any manner other than its intended use is not covered by this warranty. The manufacturer assumes no responsibility whatsoever for
product installation during the limited lifetime warranty.
The manufacturer disclaims any and all warranties. The duration of any implied warranty which cannot be disclaimed is limited to the
time period as specied in the expressed warranty. The manufacturer shall not be liable for incidental, consequential, or special damages
arising out of or in connection with product use or performance except as may otherwise be accorded by law. This warranty gives
specic rights, and you may have other rights which vary from state to state.
To obtain warranty service, call our customer service department at [phone] for return authorization and shipping instructions so
that we may repair or replace the product. No warranty claim will be processed without a copy of the receipt as proof of purchase.

3 HOMEDEPOT.COM
Please contact 1-855-HDGLACIER for further assistance.
PLANNING INSTALLATION
□Please identify all the parts and hardware pieces before you begin.
□When laying out the parts, place them on a soft surface to prevent scratching.
HARDWARE INCLUDED
NOTE: Hardware shown to actual size.
Pre-Installation
Part Description Quantity
AA Wedge 4
BB Small end cap 1
CC Large end cap 1
DD Tape strips 2
AA BB
CC DD

4
Pre-Installation (continued)
PACKAGE CONTENTS
Part Description Quantity
A Short tapered tube 2
B Long tapered tube 2
C Twist tube 1
D Shallow wire shelf 3
E Deep wire shelf 1
C
A
A
B
D
D
E
D
B

5 HOMEDEPOT.COM
Please contact 1-855-HDGLACIER for further assistance.
Installation (continued)
2Connecting the shelves to the tube
NOTE: The tapered end of the long tube (B) is at the
bottom.
NOTE: Shelves (D) can be adjusted by moving the
wedges (AA) up or down.
□Place a wedge (AA) (tapered or rounded end up) on one of
the long tapered tube (B) approximately half way down.
□Slide a shallow wire shelf (D) down the tube and t over
the wedge.
□Place a wedge (AA) (tapered or rounded end up) on the
long tapered tube (B).
□Slide another shallow wire shelf (D) down the tube and t
over the wedge (AA). This is the lower tube assembly.
1Connecting the shelves to the tube
NOTE: The tapered end of the long tube (B) is at the
bottom.
NOTE: Shelves (D and E) can be adjusted by moving the
wedges (AA) up or down.
□Place a wedge (AA) (tapered or rounded end up) on one of
the long tapered tube (B) approximately half way down.
□Slide the deep wire shelf (E) down the tube and t over
the wedge.
□Place a wedge (AA) (tapered or rounded end up) on the
long tapered tube (B).
□Slide a shallow wire shelf (D) down the tube and t over the
wedge (AA). This is the upper tube assembly.
D
AA
B
E
D
D
AA
B
AA
B
AA
B

6
Installation (continued)
3Connecting the two tubes
□
□Place the tapered end of the tube (B) with the two
shelves (D, E) on it into the untapered end of the other
tube (B) with the shelves (D) on it.
4Connecting the tapered tube to the
twist tube
NOTE: If the twist tube (C) does not extend, loosen the
tubes by twisting the tubes in the opposite direction until
the tubes slide up and down freely.
□Place the large end cap (CC) on the twist tube (C).
□Insert the tapered end of the long tapered tube (B) into the
top of the twist tube (C).
5Connecting the short tube to the top
shelf assembly
NOTE: If the assembly will be installed on a tub ledge,
rst place the tube assembly on the tub ledge and measure
the distance between the top tube and the ceiling.
NOTE: If this distance is greater than 16 in., refer to the
Troubleshooting section at the end of this manual.
□Place the tapered end of the short tapered tube (A) into the
untapered end of the upper tube assembly.
□Place the small end cap (BB) on the short tapered tube (A).
tapered end
B
D
top shelf assembly
bottom shelf assembly
E
D
D
Bbottom shelf assembly
C
top of twist tube (C)
BB
A
top shelf assembly
CC

7 HOMEDEPOT.COM
Please contact 1-855-HDGLACIER for further assistance.
Installation (continued)
7Add tape strips to the tube seams
□Place the tape strips (DD) around the seams of the tubes.
6Assembly installation
NOTE: Make sure each end of the assembly is touching
the ceiling and tub ledge or shower stall oor.
NOTE: Do not over tighten the twist tube (C) as this may
cause damage to the internal lock.
□Lift the entire assembly into its nal location.
□While holding the small tube of the twist tube (C), pull the
large tube down to increase the assembly height.
□Secure the assembly into place by twisting the larger tube of
the twist tube (C) counterclockwise 4 to 6 times (2 full turns)
or until tight.
C
pull the large tube
down and tighten
hold the small tube
DD

8
[Heading goes here]
Care and Cleaning
□Cleaning with a dry cloth may be sufcient.
□For other stains or marks, wipe gently with a damp cloth.
□Do not use strong detergents or abrasive cleaners; they may damage the surface of this product.
Troubleshooting
□If this distance is greater than 16 in., one short tapered tube (A) should be added to the top of the assembly.
□If this distance is greater than 32 in., two short tapered tubes (A) should be added to the top of the assembly.

Questions, problems, missing parts?
Before returning to the store, call Glacier Bay Customer Service
8 a.m. - 6 p.m., EST, Monday - Friday
1-855-hdglacier
hOMedePOT.cOM
Retain this manual for future use.
IS2197

THANK YOU
Agradecemos la conanza que ha depositado en Glacier Bay a través de la adquisición de esta barra organizadora Premium. Nos esforzamos
constantemente en crear productos de calidad diseñados para embellecer su hogar. Visítenos en línea y vea nuestra línea completa de productos
para realizar mejoras en su hogar. ¡Gracias por elegir Glacier Bay!
GUÍA DE USO Y CUIDADO
BARRA ORGANIZADORA PREMIUM
¿Tiene preguntas, problemas, o faltan piezas?
Antes de regresar a la tienda, llame a Servicio al Cliente
de Glacier Bay de lunes a viernes de 8 a.m. a 6 p.m., hora local del Este
1-855-HDGLACIER
HOmEDEpOT.COm
Núm. de artículo 892 204
Núm. de modelo 2190SSHD