Global Industrial cd 246558 User manual

Continental Dynamics
USER SERVICING INSTRUCTIONS
• DO NOT allow water or steam to get on or into the fan motor housing.
• DO NOT use gasoline, thinner or benzene on or near the fan.
• It is recommended to periodically clean this unit. To clean unit, lightly run a vacuum
cleaner nozzle over the fan grill to remove any dust or dirt that may have accumulated
inside or on the unit.
• Wipe all parts with a soft cloth. Soft cloth may be moistened with a mild soap solution.
• Dry all parts completely before reassembling or re-connecting the fan to the wall outlet.
• Keep surfaces dry and clean for a longer lasting finish.
• All repairs must be done by authorized technician.
• Do not modify equipment or power cord, Warranty will be voided.
WARNING
!
!
Unplug fan before cleaning or performing maintenance.
WARNING
!
!
Unit is not intended for use by children or persons with
reduced physical, sensory or mental capabilities or
lack of experience and knowledge, unless they have
been given supervision or instruction concerning use
by a person responsible for their safety.
36” & 42” Tilting
Belt Drive Drum Fan
Instruction Manual
Model 246558 & Model 246559
By Global Industrial By Global Industrial
WARNING
!
!
This product contains chemicals which are known
to the State of California to cause cancer, birth
defects or other reproductive harm.
Continental Dynamics

READ & SAVE THESE INSTRUCTIONS
Thank you for purchasing a Fan from Global Industrial. Please Read These
Instructions Carefully Before Operation.
Please note that the actual appearance of the product purchased is subject to
change and may vary from the illustrations in this instructions manual due to
continuous product upgrades. Although there may be slight differences
between the actual product and the illustrated version, it will not in any way
affect the performance of the product you purchased.
2www.globalindustrial.com Model 246558 & Model 246559 3
WHEEL ASSEMBLY
1. Insert the wheel axel into the frame and align hole A with pop-up button B.
Insert until pop-up button B pops-up through hole A and secures wheel in
place. Repeat process for other side.
TECHNICAL SPECIFICATION
Model 246558 Model 246559
Fan Diameter 36” 42”
Max Airflow (CFM) 10,500/9,800 13,400/12,500
Power Supply / Frequency 120V/60Hz 120V/60Hz
14.570.4sPMA
Dimension (W” x D” x H”) 42 x 141/2x 421/248 x 141/2x 491/2
WARNING
!!
• To reduce the risk of fire or electrical shock, do not expose to water or rain.
• To reduce the risk of fire or electrical shock, do not use fan with a solid state
speed control device.
• To prevent risk of injury or electrical shock, do not touch fan when hands are wet.
• Unplug fan before moving or transporting fan.
• Unplug fan before cleaning or performing maintenance.
• Any modification to fan will void warranty.
• Unplug fan when not in use. Unplug fan by holding the plug. To reduce injury
and prevent breakage, do not unplug by holding the cord.
• DO NOT use fan if power cord or plug is broken.
• DO NOT use fan with an extension cord.
• DO NOT use fan near fire or water.
• DO NOT use outdoors. For indoor use only.
• DO NOT insert hands into the guard or near moveable parts.
• Make sure front and rear guards are screwed in place and secured in locking
position before operation.
OPERATING INSTRUCTIONS
1. AIRFLOW: To adjust airflow upward or downward, simply tilt fan head to the
desired angle.
2. SPEED CONTROL: This 2-speed fan utilizes a rotary control switch for speed
control. (0 = Stop, 1 = Low, 2 = High)
Note: Low Voltage less than 110V or High Voltage greater than 120V
may cause damage to motor.
screw
drawing 2
hole A
hole B
drawing 1
D