Global Industrial 493780BK User manual

1MODEL # 493780BK
User's manual Manual del usuario Manuel de l'utilisateur
Customer Service
US: 1-800-645-2986
Servicio de atención al Cliente
US: 1-800-645-2986
Service à la clientèle
Canada: 888-645-2986
Caution:
• Requires 2 people for
assembly.
• Ensure you are using proper
PPE such as glove, steel
toe boots, safety glasses.
• Perform regular inspections
on the hardware by
checking their tightness
every 4 months.
• If table height isn't adjusting,
remove items off table
and inspect. Do not force
adjustment.
Frame & Leg Kit Model: 493780BK
Frame and Leg Kit for 48/60/72 Manual Hand
Crank Adjustable Workbench - Black
Tools Needed
Components
Hardware

2
Hand Crank Adjustable Workbench
1) Lay out all components and hardware to ensure that you have all the
components and hardware. Fully separate the Crossbard ends ( Ref 5). You will
find the Crossbar Center Rails (Ref 6) Inside.
2) Prop up the assemblies from Step 1 As shown. Insert x4 M6*10 machine screws (Ref 21)
through the holes of each Crossbar End (Ref 5) going into the Leg (Ref 1) and tighten the
screws. Then connect the other Leg (Ref 2) with the other Crossbar End (Ref 5) in the same way.
3) Attach the Side Brackets (Ref 8) to the assemblies from Step 2, as shown. Insert two M6*10
Machine Scerws (Ref 21) through the two holes of the Side Bracket (Ref 8) going into the
Crossbar End/Leg Assembly.
Repeat Step 3 with the other assemblies.
4) Slide the two Crossbar Center Rails (Ref 6) into the two Crossbar Ends (Ref 5)
5) Put the Rotating Bar (Ref 7) into the assemblies from step 4.
User Manual

3
Hand Crank Adjustable Workbench
7) Please insert 8 M6*10 machine screws (Ref 21) through the holes in each crossbar end (Ref 5) going
into the Center Rails (REf 6) and tighten the screws. Then insert x2 M4*6 machine screws (Ref 24) into
the Rotating Bar (Ref 7) and tighten as shown. Insert the Handlebar (Ref 10) into the Handle Holder (Ref
9). Then insert x2 M4*6 machine screws (Ref 24) into the Handle Holder (Ref 9) and tighten them.
8) Attach the Short Rungs (Ref 11) to the Leg with x4 M6*10 Furniture Scerws
(Ref 25). Then attach the Long Rung (Ref 12) to the SHort Rungs (Ref 11) with
x4 M6*16 Machine Screws (Ref 21) and x4 Butterfly Nut M6 ( Ref 26).
9) Attach a foor (Ref 3) with x4 M6*16 machine screws (Ref 22) into each
Legs and tighten screws. Connect x2 glides (Ref 4) together into each foot,
10) Turn the table over.
6) Place the table under the accessories and place it in the corect position. Then attach
the Handle Holder (Ref 9) to the Table Board with x4 M5*16 wood screws (Ref 23) and
tighten them.
Then connect the Table Board to the desk frame with x6 M5*16 wood screws (Ref 23)
and tighten them.
User Manual