Godex T-10 User manual

:Rev. B
:2018.09.18
:313-041000-403

1 Box Contents
2 Getting to Know Your T-10/T-20 Rewinder
Device Overview
3 Setting Up the Rewinder
Connection
Loading the Label
Install the Plate
Remove the Plate
Label Core in Different Sizes
Match Up the Empty Label Core and Core Adapter
The Modes of Rewinding
4
What’s the Status of the Rewinder
LED Indicator
When the Rewinder is Full
5
Troubleshooting
Sensing Error
Idle Load
Appendix
Product Specifications
VR(Speed Adjustment)

Tighten to lock

LOCK
LOOSEN
Install
Remove

2
4
Holding on the Dancer Arm Holding on the Dancer Arm
3
Orange Orange

To Set up:
1. Make sure the power is switched off.
2. Place the Dancer Arm at its highest point on either side of the rewinder.
3. Turn on the power while holding on the Dancer Arm.
Once the power is on, an orange light should light up and that will bring the rewinder
into the “Motor Fixed Speed Mode.”
4. Release the Dancer Arm and the rewinder will be rewinding at a fix speed.
5. To stop, switch off the power.
5

LED INDICATOR

2