GoFit CHIN-UP BAR Parts list manual

INCLUDED HARDWARE
• 1 Adjustable Chin-Up Bar
• 4 Mounting Brackets—2 for mounting high in your door and two for
mounting the bar low in the doorway for doing push ups and sit ups.
• 20 Mounting Screws—5 screws for each mounting bracket.
*DO NOT install Chin-Up Bar without included and required hardware.
If you do not find all of the necessary hardware in the package/box,
contact Customer Service via the GoFit web site (www.gofit.net).
CHIN-UP BAR—USAGE
• Please read and follow all warnings, information, and instructions.
• CHIN-UP BAR WEIGHT LIMIT: 300 pounds when properly mounted.
• The Chin-Up Bar is NOT a toy; keep out of reach of children.
If allowing anyone under 18 to use it for exercise purposes, they must
have constant adult supervision. The Chin-Up Bar could pose a hazard
to children and pets, therefore must NEVER be left unattended.
• DO NOT swing on, or from, the bar.
• DO NOT hang upside down.
• DO NOT extend the bar past extension marks.
• When first attempting any exercise, use caution while determining
your physical limitations.
• GoFit, LLC is not responsible for any personal property damage that
may occur while using the Chin-Up Bar.
• The Chin-Up Bar should only be used for its intended purpose.
• Be sure to wear appropriate exercise clothing and footwear,
such as sneakers or exercise shoes.
• The Chin-Up Bar is not recommended for use during pregnancy.
CHIN-UP BAR—MAINTENANCE AND CARE
• Clean the Chin-Up Bar with mild soap and warm water. DO NOT use
abrasive or chemical cleaners. DO NOT immerse Chin-Up Bar into water.
Towel dry, or let the Chin-Up Bar air dry completely.
• Keep Chin-Up Bar out of direct sunlight. The Chin-Up Bar should not
be placed anywhere where it would be exposed to extreme high or low
temperatures, heat sources or open flame.
USAGE & CARE
CHIN-UP BAR
Read and follow all warnings and information before use.
Serious injury or fatality may occur.
Included Hardware

*DO NOT mount Chin-Up Bar in doorways wider than 36".
MOUNTING UPPER BRACKETS FOR CHIN UPS
1. Measure one side of door jamb at approximately 3" from top
of door jamb. Mark this spot for reference.
2. Position the silver bracket with the tabs up—placing the bottom
on your mark. Leave about 1/8" between the raise of the jamb
and the bracket. Locking tabs must be able to rotate.
3. Mark all mounting holes and set bracket aside.
4. Drill pilots holes with 1/16" bit.
5. Secure bracket to jamb with screws provided.
Repeat for opposite jamb.
MOUNTING LOWER BRACKETS FOR PUSH UPS
1. Measure 6" from floor. Mark this spot for reference.
2. Repeat steps 2 thru 5 from above.
BAR INSTALLATION
After installing brackets, make sure tabs are rotated to the outer side
of the bracket. Place one end of bar in first bracket, then the other.
To lock the bar into the brackets, simply rotate the tabs toward the bar.
INSTRUCTIONS
Tabs Rotated Out Locked Position—Tabs Rotated In
1
3
2
4
©2015 GoFit, LLC. Tulsa, OK Made In China. Log on to www.gofit.net for more details and product information. GoFit reserves
the right to modify the product or content without notice. WARNING: Exercise programs of any kind present an inherent danger to
the participant. Serious or fatal injury can occur. Consult your doctor before beginning any exercise program. All GoFit equipment
is intended to be used by adults only in the manner shown/illustrated/ described. Anyone under the age of 18 should have adult
supervision. Always read and follow all warnings and information (if included). Always use proper techniques and common sense
when exercising. Always check your equipment thoroughly for any sign of defect. If any defect is found, discontinue use immediately
and contact customer service for further assistance. This product is not intended for commercial use.
CHIN-UP BAR
Read and follow all warnings and information before use.
Serious injury or fatality may occur.