goliath Mad Dog User manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
- (1) this device may not cause harmful interference, and
- (2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Do not mix old and new batteries.
Do not mix alkaline standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are only to be charged under adult supervision.
Rechargeable batteries are to be removed from the toy before being charged.
Different types of batteries or new and used batteries are not to be mixed.
Batteries are to be inserted with the correct polarity. Exhausted batteries are to
be removed from the toy. The supply terminals are not to be short-circuited.
© 2019 Goliath, Vijzelpad 80, 8051 KR Hattem, the Netherlands. Pressman Toy Corp, 3701 West Plano
Parkway, Suite 100, Plano, TX 75075, USA. Crown & Andrews Pty Ltd., Unit D, 21 Loyalty Road, North
Rocks, NSW 2151, Australia. Elephanta Marketing Ltd., PO Box 7277, Wellington South, 6242, New
Zealand. Vivid Toy Group Ltd., GU3 1LS, UK. Packaging must be retained since it contains important
information. Color and contents may vary. Made in China. www.goliathgames.com
Requires 2 AA batteries (not included).
31031
3103110 v7 0519
ATTENTION!
This device is marked with the selective sorting symbol on waste electrical and electronic equipment.
This means that this product should be supported by a selective collection system in accordance with
applicable regulations in order to be either recycled or dismantled in order to reduce any impact on
the environment. The batteries, submitted to a specic collection system, must be removed from the
product and disposed of separately. When that the batteries are not to be extracted, the product must
be delivered to an appropriate collection center for recycling is complete. Electrical and electronic
products as well as batteries that have not been sorted before disposal are potentially dangerous for
the environment and human health due to the presence of hazardous substances. For more information,
contact your local or regional government.
CAUTION
1. Do not reset Mad Dog while he is still jumping/barking. Only reset after he moves
forward completely and nishes barking.
2. If Mad Dog does not function correctly, slide the power switch to OFF, reset and
slide the power switch to ON again.
For 2+ Players
Ages 4 and Up
Warning.
Small parts. Choking hazard.

The youngest player starts the game. Spin the spinner to see the color and amount of
dog bones to steal from Mad Dog (1 blue bone, 2 yellow bones, etc).
Using the puppy tweezers, carefully reach into the dog bowl and pull out the bones
indicated on the spinner. You may need to dig around for the right color, but be careful
— move too much and you might wake him up!
Once the rst player is done retrieving their bones, play then passes to the left and the
next player spins the spinner.
When Mad Dog wakes up, he will jump up and bark at you! The player who woke him
up is now out of the game. The remaining players reset the game for another round by
putting Mad Dog back into sleep mode and putting all the dog bones back in the dog
bowl. Keep playing rounds until there is just one player left.
The last player remaining after all other players have been knocked out of the game
is the winner!
1 Mad Dog, 1 Dog Bowl, 1 Pair of Puppy Tweezers, 1 Spinner, 32 Colored Bones
Place all of the bones in the dog bowl, making sure that the colors are mixed up. Keep
the puppy tweezers in reach of all players. Before play, switch the ON/OFF button,
located at the bottom of the food bowl, to ON.
To steal bones from Mad Dog without waking him up.
Align the spaces on the inside
of the front paws with the posts
on the side of the dog bowl and
snap together.
Insert batteries: Loosen the screw
on the battery compartment,
located on the underside of the
dog bowl, and remove the door.
Insert 2 “AA” size batteries, making
sure to align the + and - with the
markings in the plastic. Replace
the door and tighten the screws.
To set Mad Dog into sleep mode,
turn his head counter-clockwise
and push his body back behind
the dog bowl, so that his cheek is
resting on the bowl’s platform and
you hear a “click”.
PLAYING THE GAME
CONTENTS
OBJECT
SET UP
2WINNING THE GAME
NOTES
3
If Mad Dog’s head does not lock when you push it down, you can reset
the game as follows:
1. Push the dog’s body into the sleeping position, with his head tilted on the
side slightly, while holding him in place.
2. Turn the power switch to the “ON” position and hold the bottom of the dog
bowl down with your other hand. While doing this, you should hear the motor
sound. Just as it starts, release the dog’s body and let him jump forward.
3. The game should now be reset. If not, repeat the last step.
4. If Mad Dog takes a while to jump up, the batteries may be weakening. To
improve, replace with new batteries.
BATTERIES
NOT
INCLUDED
1