Graco Modes DUO User manual

MODES™ DUO
• featuring
•
• Owner’s Manua
©2015 Graco PD348896B 12/15

2
2-A MODES™ DUO Use Positions
2-B Parts List • Liste des pièces
1 WARNING
2 Features
Pages 4-9
Pages 10-12
3-A To Open Stroller
3-B Rear Wheels
3-C Front Wheels
3-D Bench Seat
3-E Parent’s Cupholder
3-F Toddler Seats
3 Assembly Pages 13-23

3
4-A Car Seat/Toddler Seat Attachment Mounts
4-B To Use Toddler Seats
4-C To Secure Child
4-D To Recline
4-E Brakes
4-F Swivel Wheels
4-G To Attach Graco® Infant Car Seat to Rear Position
4-H To Attach Graco® Infant Car Seat to Front Position
4-I To Fold Stroller Frame
4-J Harness Covers
4 Use Pages 24-49
5-A Care & Maintenance
5-B Replacement Parts • Warranty Information
5-C Product Registration
5 Cleaning Pages 50-52

4
Failure to follow these warnings and the assembly
instructions could result in serious injury or death.
Only use product as instructed.
PLEASE SAVE OWNER’S
MANUAL FOR FUTURE USE.
ADULT ASSEMBLY REQUIRED.
NEVER LEAVE child
unattended. Always keep
child in view while in stroller.
AVOID SERIOUS INJURY from
falling or sliding out. Always use
seat belt. After fastening
buckles, adjust belts to get a snug
fit around your child.
AVOID FINGER ENTRAPMENT:
Use care when folding and
unfolding the stroller. Be certain
the stroller is fully erected and
latched before allowing your child
near the stroller.
AVOID STRANGULATION:
DO NOT place items with a string
around your child’s
neck, suspend strings from
this product, or attach strings
to toys.
NEVER USE STROLLER ON
STAIRS or escalators. You may
suddenly lose control of the
stroller or your child may fall out.
Also, use extra care when going
up or down a step or curb.
STROLLER TO BE USED only
at walking speed. Product not
intended for use while jogging,
skating, etc.
USE OF THE FRONT SEAT, REAR
SEAT, BENCH SEAT OR
STANDING PLATFORM with a
child weighing more than 50 lb
(22.7 kg) or taller than
45 in. (114.3 cm) will cause
excessive wear and stress on the
stroller.
TIPPING HAZARD! DO NOT
OVERLOAD FRONT SEAT, REAR
SEAT, BENCH SEAT OR
STANDING PLATFORM PAST
THE MANUFACTURERS
RECOMMENDED WEIGHT
RATING.
TO PREVENT TIPPING, do not
place more than 1 lb (.4 kg) on
the parent cupholder.
TO AVOID BURNS, never put hot
liquids in the parent’s cupholder.
TO PREVENT A HAZARDOUS,
UNSTABLE CONDITION, never
place purses, shopping bags,
parcels or accessory items on the
handle or canopy.

5
TO PREVENT A HAZARDOUS,
UNSTABLE CONDITION, do not
place more than 10 lb
(4.5 kg) in the storage basket.
DO NOT use storage basket as a
child carrier.
NEVER ALLOW YOUR
STROLLER to be used as a toy.
DISCONTINUE USING YOUR
STROLLER should it become
damaged or broken.
ONLY USE THE TODDLER
SEATS PROVIDED WITH THIS
STROLLER.
USING GRACO® INFANT CAR
SEAT WITH STROLLER:
• TO AVOID INJURY TO YOUR
CHILD: THIS STROLLER IS
ONLY COMPATIBLE WITH
GRACO® SNUGRIDE®
INFANT CAR SEATS WITH
CLICK CONNECT™. Only use
with Graco®
infant car
seats that
have the
Click
Connect™ logo. Improper use
of this stroller with other
manufacturers’ car seats may
result in serious injury or
death.
• READ THE MANUAL provided
with your Graco car seat
before using it with your
stroller.
• ALWAYS SECURE your child
with the car seat harness when
using the car seat in the stroller.
If your child is already in the car
seat, check that the child is
secured with the harness.
TO PUT CHILDREN IN THE
STROLLER: You may use this
stroller with two infant car seats.
Refer to the sections “To Attach
Graco® Infant Car Seat to Rear
Position” and “To Attach Graco®
Infant Car Seat to Front Position”
pages 41-48. Only use a
GRACO® SNUGRIDE®CLICK
CONNECT™CAR SEAT.
10

10
2-A MODES™ DUO Use Positions
WARNING
DO NOT allow child
to stand on platform
facing backwards.
To avoid falling, child
must hold onto
handles.

11

12
2-B Parts List
All models
2X 2X
This model may not
include some
features shown
below. Check that
you have all the parts
for this model
BEFORE assembling
your product.
No tools required.
2X 2X
2X 2X
2X
2X
2X 2X

13
3-A To Open Stroller
1. Open stroller lock.
Be sure to place stroller on top of a piece of cardboard or some other
protective cover to prevent any damage to floor.
2. Lift handle of stroller up.

14
3. CHECK that the stroller is
completely latched open every
time you open the stroller and
before continuing with the rest of
the assembly steps.
3-B Rear Wheels
1. Insert axle rod through axle
opening.
Rear Axle
SNAP!

15
2X
4. Place washer on axle.
3. Place wheel on axle.
2. Firmly attach hub adapter onto
wheel.
2X
Rear Wheelss

16
6. Snap hubcap over pin as shown.
Repeat with other hubcap.
5. Push straight side of pin through
axle hole. Pin will separate
around the axle. Curved end of
pin MUST face up as shown.
Repeat steps 2-5 on other side.
2X
SNAP!

17
3-C Front Wheels
SNAP!
1. Attach front wheels to front leg
tubes as shown.
2. CHECK that wheels are securely
attached by pulling on wheel
assembly.
2X

18
3-D Bench Seat
WARNING
Do not allow child to
stand on bench seat.
Never use bench
seat in motor vehicle
or on any other
product.
1. Slide bench seat over tube with
hooks on the bottom of the bench
seat fastening under tube.
2. Press down on front of bench
seat to secure.
SNAP!

19
3-E Parent’s Cupholder
1. Line up opening in cupholder with
mount on stroller and press onto
stroller tube.
2. Make sure cupholder is snapped
securely into mount.
Opening

20
3-F Toddler Seats
2X 2X
1. Insert seat wire into openings on
sides of toddler seat.
2. Secure flaps around wire with 3
snaps.
Repeat on other toddler seat.

21
2. Fasten hook and loop tape on the
rear of canopy as shown. MAKE
SURE canopy is always fastened
with the hook and loop tape when
toddler seat is in use.
1. Insert canopy wire into the
canopy pivots on each side of the
toddler seat as shown.
SNAP!
Canopy •

22
WARNING
Always secure your
child with the seat belt.
The armbar is not a
restraint device. DO
NOT lift the stroller by
the child’s armbar. Use
care when snapping
the armbar on the
stroller with a child in
the stroller.
Child’s Armbar
2X
1. Attach child’s armbar onto armbar
mounts.

23
2. To open, press button on bottom
and rotate child’s armbar up.
3. To remove child’s armbar, press
buttons on bottom on both ends
and lift off.
Press release buttons under seat
pad and pull armbar mounts off.

24
4-A Car Seat/Toddler Seat Attachment Mounts
1. To attach a car seat or toddler
seat, place attachment mounts in
upright position by:
a. Pulling attachment mounts
inward and,
b. rotating up,
c. snapping into place.
ab
SNAP!
c
Rear Position Mounts
WARNING
DO NOT adjust mounts with child in the bench seat or allow child to play
with mounts.