Graff G-6156 Series User manual

4-15/16”
(126mm)
8-1/2”
(216mm)
M15x1
1”
Ø(25mm)
1-1/4”
Ø(32mm)
1-15/16”
Ø(50mm)
Model
Modelo
G-6156-***
1
IOG 5069.15 Rev. 2 July 2018
1-15/16"
50mm
O
1-5/16" 34mm
2-3/16"
56mm
O
LM57B C19B

G-6156-***
2
IOG 5069.15
9
11
8
12
13
10
6
7
Rev. 2 July 2018
4
5
3
2
1

3
IOG 5069.15 Rev. 2 July 2018
PERNO
PERNO

4
IOG 5069.15
B
A
1
Rev. 2 July 2018
D
E
L
T
A
D
E
L
T
A

5
IOG 5069.15
B
B A
A
B
1
B
B
Put the lever body (4) with the screw (5) on the valve spindle
extension (B) - fig. 2.4. Check if it is possible to obtain the lever
position as shown in the picture 2.8. If you cannot obtain satisfactory
position of the lever (4) in relation to the edge of the installation
surface (a clear shift by the angle Δfrom the required position is
visible – as shown in the fig. 2.5), take off the lever (4) from the valve
spindle extension (B) - fig. 2.6. Unscrew the bolt (A) and switch
the valve spindle extension (B) by one tooth on the splines of the valve
head and screw in the bolt back (A) - fig. 2.7 .
Put the lever (4) back on the valve spindle extension (B) and check if
the lever is set correctly (4) - fig. 2.8.
If the lever (4) position is correct, tighten the screw (5) with the
hex key (K1) as shown in fig. 2.9.
If the lever (4) position is still incorrect – move the valve spindle
extension (B) by one more tooth on the splines of the valve head
and check again if the lever (4) position is correct.
12
C
C
Rev. 2 July 2018

6
IOG 5069.15 Rev. 2 July 2018
R1
R2
9
8
7
6
R3 R3
8
9
7
9
7R4
R5
8
R3
www.graff-designs.com

7
IOG 5069.15
C
12
When the lever is set as recommended in the manual: Turning the lever by
180° to the left results in outflow of water through the hand shower,
returning the lever to the starting setpoint results in the outflow of water
through the spout.
Para la posición de la manilla recomendada en el manual: Girar la manilla
en180°a laizquierda causa la salida del agua por la regadera, volver con la
manilla a la posición inicial causa la salida del agua por el caño.
Rev. 2 July 2018
7
9
10