Graham Field Everest & Jennings 907637EX User manual

907637EX-INS-LAB-RevA19 1
907637EX: SPREADER BAR REMOVAL & INSTALLATION
INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE
WARNING: Important! Read and understand these instructions before installing or
removing the Spreader Bar. If you do not understand any part of these warnings, cautions
or instructions, contact a healthcare professional for direction in the use of this product. If
the Spreader Bar is not properly installed, personal injury and damage to the Spreader Bar
could result.
WARNING: If components are damaged or missing, contact your distributor immediately.
DO NOT use substitute parts. Use only Everest & Jennings replacement parts.
Non-Everest & Jennings replacement parts could cause personal injury and damage to the
Spreader Bar.
WARNING: Cancer and Reproductive Harm - www.p65warnings.ca.gov.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury
caused by improper assembly or use of this product.
SPREADER BAR REMOVAL (SEE PICTURES)
right knob
right spreader bar
attachment rod
left backpost
spreader bar
right backpost
left backpost
right backpost
step 1 step 2
1. Unscrew knob from right spreader bar attachment rod as shown at above left; remove knob.
2. Lift spreader bar gently from right spreader bar attachment rod and pull it back a little, free of
spreader bar, as shown at above right. Allow spreader bar to rotate and drop to the left.
3. Unscrew knob from left spreader bar
attachment rod as shown at right; remove
knob.
4. Pull off spreader bar from left spreader
bar attachment rod as shown at right and
detach it completely.
Info: Retain all components for future use.
left backpost
right backpost
left knob
left
spreader bar
attachment rod

907637EX-INS-LAB-RevA19 2
1.770.368.4700
Information contained herein is subject to change.
The most current and complete product information can be found on our website.
www.grahameld.com
© 2019, GF Health Products, Inc. All Rights Reserved.
Everest & Jennings is a trademark of GF Health Products, Inc., One Graham-Field Way, Atlanta GA 30340-3140
GF Health Products, Inc. is an ISO 13485 Certied Company.
SPREADER BAR INSTALLATION (SEE PICTURES)
left backpost
spreader
bar hole
spreader bar
slot
spreader
bar hole
left backpost
spreader bar
right backpost
step 1 step 2
1. Install knob through spreader bar hole into left spreader bar attachment rod as shown at above
left; screw in until secure.
2. Lift right end of spreader bar, position spreader bar slot over right spreader bar attachment
rod, and push down gently to trap right spreader bar slot on right backpost spreader bar
attachment rod as shown at above right.
3. Install knob through spreader bar slot
into right spreader bar attachment rod
as shown at right; screw in until secure,
ensuring spreader bar is horizontal and
right end of spreader bar is secure.
WARNING: Ensure Spreader Bar
is securely installed, as described,
before use.
left backpost
spreader bar shown
correctly installed
right backpost