Grundfos Hydro 2000 Solo-E User manual

GRUNDFOS INSTRUCTIONS
i
1Installation
2Electrical connection
Hydro 2000 Solo-E
1
~ H
y
dro Multi-E
Quick Guide
2
21 12
The Hydro 2000 Solo-E booster set must
be installed in a well ventilated room to
ensure adequate cooling of the pump.
Hydro 2000 Solo-E is not suitable for
outdoor installation.
Do not start the booster set until it has
been filled with water and vented.
To avoid resonance, expansion joints and
pipe hangers should be fitted on both
sides of the booster set.
1: Expansion joints
2: Pipe hangers
The electrical connection must be car-
ried out by an authorized electrician in
accordance with local regulations.
The electricity supply must be con-
nected to the on/off switch of the
booster set.

96 42 81 49 1102 GB
Repl. V7 14 49 87 1199
Being responsible is our foundation
Thinking ahead makes it possible
Innovation is the essence
3Setpoint setting
The setpoint is set by means of the control
panel on the motor terminal box.
Set the desired setpoint by pressing the
button “+” or “–”.
Green (operation)
Red (fault)
0
5
10
[bar]
The yellow light fields on the control panel
indicate the setpoint.
Subject to alterations.