ENGLISH24
OPERATION _____________________________
Notes
Upon delivery, the glass jar E, lid C,
measuring cup A, sealing rings D H,
cutter unit I and the jug base G are
already assembled.
Preparation
Remove all packaging and stickers materials
and dispose of them according to the
applicable legal regulation.
Prior to first use
The parts must be cleaned prior to first use.
To do this, proceed as follows:
1 Take the entire unit off the motor housing J
and place it on a level surface, e.g. on the
kitchen counter.
2 The lid C can be removed from the glass
jug by pushing on it lightly upwards with
your thumb.
3 Turn the measuring cup counter clockwise
as far as it will go and take it upwards out
of the lid opening B.
4 Take the sealing ring D off of the lid. Due
to its flexibility, the sealing ring can be lifted
off with your fingers. Do not use any tools
as this could damage the sealing ring.
5 Now set the glass jug with the opening
facing down on a level surface.
6 Take off the jug base by turning it counter
clockwise until it comes off (see diag.). The
cutter unit inside the jug base stays in the
glass jug.
7 The cutter unit can now carefully be lifted
out of the jug (see diag.). The sealing ring
H can now be removed from the cutter unit.
Caution
The blades are very sharp. Therefore do
not touch the cutter unit with your fingers.
Risk of injury!
8 Clean all parts, with the exception of the
motor housing as described in “Cleaning
and Care”.
9 Then re-assemble the jug blender in the
reverse order. Set the glass jug with the
opening facing down on a level surface.
10 Lay the cutter unit sealing ring in the middle
on the glass jug.
11 Then insert the cutter unit with the blades
evenly into the opening of the base of the
glass jug (see diag.). Push down a little so that
the sealing ring presses onto the cutter unit.
12 Screw the jug base onto the glass jug by
turning it clockwise (see diag.). Hold the jug
handle F and screw the jug base on tightly.
13 Put the sealing ring on the lid. Make sure that
the sealing ring is sitting on the lid evenly.
14 Press the lid levelly onto the glass jug.
