3
Enrolling
To enrol the GSD Keyfob:
1. On the GSD-i70 Panel, navigate to Keyfobs - Add Keyfob Wizard
- Enrol RF Keyfob, pressk OK.
2. On the Keyfob press and hold for 5 seconds. When the red LED
turns on, release the button immediately.
3. Click Next after the message ‘Keyfob enrolled’ is displayed.
4. Press any button on the Keyfob to show signal strength, then press Next
5. Change the Keyfob name as desired and press Next.
6. Assign the Keyfob to a desired user from the list displayed. The Keyfob now
has this users permissions.
Full Set
LED Status:
Green LED: Solid = Unset, Fast Flashing = In range,
Slow Flash = Out of the range of the GSD-i70 Panel.
Red LED: Solid = Alarm.
Blue LED: Solid = Full Set, Flashing = Part Set or some Areas Set
Amber LED: Solid = Open zone or Fault. View open zones or faults on
the GSD-i70 Panel.
Note: The Keyfob will indicate if it is in or out of range of the panel by flashing
the green LED before indicating the system status LED.
e.g - In range of the Panel, the green LED will flash fast.
- Out of range of the Panel, the green LED will flash slowly.
LED indicator
Unset
Part Set B
Part Set A Keyfob operation
Flashes Fast,
System sounds exit tones
and starts Full Set
Flashing
fast
Flashing
fast Solid,
System is unset
Flashing
fast Two flashes,
System is Part Set A
A
Flashing
fast Two flashes,
System is Part Set B
B
Flashing
fast Solid,
System is in alarm
AB
FullSet:
Press and hold until then
Unsetting:
Press and hold until then
PartSet A:
Press and hold until then
PartSet B:
Press and hold until then
Panic Alarm:
Press and hold & until then
Operation Instructions
Keyfob features
2 Operation Instructions
