H-P Products Vroom24 User manual

Vroom24 Cabinet Installation
1.
Locate cardboard
template inside
the cabinet.
2.
Place mounting
bracket in tem-
plate.
Secure with 5
screws as
shown.
3.
Remove the
cardboard
Template.
4.
Install the side
panels. Flex them
so the edges tuck
under the 6 plastic
molded tabs.
5.
Attach accessory
brackets as
shown.
6.
Install the Vroom
in the mounting
bracket by push-
ing it into place as
shown. It will
snap in place
when installed
correctly.
7.
Connect the
vacuum tubing to
the Vroom’s
connector on the
back as shown.
Do NOT glue,
press fit only.
8.
Connect the low
voltage wires on
the back of the
unit.
If you require additional information on installation, please visit: www.VroomYourRoom.com
H-P Products, Inc. 512 W. Gorgas Street, Louisville, OH 44641 06-11 IH-109

If you require additional information on installation, please visit: www.VroomYourRoom.com
H-P Products, Inc. 512 W. Gorgas Street, Louisville, OH 44641
Using Your New Vroom24
INCLUDED:
Vroom
Vroom Base
Combination Floor/Rug Tool
Adjustable Wand
Tool Storage J-Brackets (2), shown installed
Installation Components/Hardware (not shown)
1. Turn it on.
Just lift the
handle until the
Vroom clicks on.
Then pull out the
handle.
3. Vacuum with the Handle
The rounded edge
of the handle
means you can
vacuum without
an attachment.
7. Store the Handle
Place the Handle inside the
green hose dock and lower it
into the storage position as
shown. Vroom turns off
automatically.
OR
4. Accessory Usage
Push Wand
Button to
adjust
length.
5. When
Finished
Flip up the
hose lock.
2. Lock the Hose
Pull out as much
hose as you want.
Then flip the
Hose Lock down
(as shown) to
hold it in place.
6. Retract the Hose
Cover the
handle end
with your hand.
The Vroom
Hose retracts
automatically.
10/14 IH-109