H3C SIC-4G-CAT6 User manual

1
H3C MSR 4G SIC-4G-CAT6 Module
SIM Card, Antenna, and Antenna
Extension Cable Installation Guides
Installing a SIM card
The SIC-4G-CAT6 interface module uses micro SIM cards.
The SIC-4G-CAT6 interface module provides two SIM card slots, but only
one is active at a time. If you install SIM cards in both slots, the SIM0 slot is
active and the SIM1 slot is in standby state by default. To perform an
active/standby switchover, execute the sim switch-to command. For
more information about the command, see 3G/4G modem management
commands in H3C MSR Router Series Layer 2—WAN Access Command
Reference.
Figure 1 SIC-4G-CAT6 interface module
(1) M0 antenna port
(2) GNSS antenna port
(3) M1 antenna port
(4) SIM0 slot
(5) SIM1 slot

2
Correct installation
To install a micro SIM card, push the card slowly into the slot until it is fully
inserted and clicks into place. To remove a micro SIM card, push the card
outward gently. The SIM card pops out.
Figure 2 Installing a micro SIM card (correct installation)
Installing an antenna
Installing a 4G antenna with a magnetic base
Insert the SMA male connector of the antenna into the antenna port M0 or
M1 and fasten the SMA male connector. Connect the SMA female
connector to the rod antenna. Make sure the antenna stand upright.
Figure 3 Installing a 4G antenna with a magnetic base

3
Figure 4 Attaching the magnetic base to a device
IMPORTANT:
For the magnetic
-base 4G antenna to have better signal receipt,
place the antenna to a location near outdoors.
Installing a GNSS antenna
Insert the SMA male connector of the GNSS antenna into the GNSS
antenna port on the panel and fasten the SMA male connector. Keep the
other end of the GNSS antenna as close to outdoors as possible.
Figure 5 Installing a GNSS antenna

4
Installing a 4G antenna
Insert the connector of the 4G antenna into the M0 antenna port or M1
antenna port, and then hold the antenna by its threaded connector to
fasten the antenna.
Figure 6 Installing a 4G antenna
When you use a 4G antenna, rotate or bend the antenna by its joint. Orient
the antenna correctly to ensure normal use of surrounding components
and devices.
Copyright © 2022, New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.