hager 4500 Series User manual

4 3/8"
111
2 3/16"
56
3 5/8"
92
.687
17
.687
17
1/2"
LHR HANDING
(SEE NOTE)
13
1/2"
RHR HANDING
(SEE NOTE)
13
TRIM MOUNTING HOLES (4X)
DRILL
1/2" HOLE
C
L
4500 Series Electric Lever Trim
Electrical Supplemental Instructions
Grade 1
I-ED00370
DEVICES COVERED IN THIS DOCUMENT:
45ET-EL Cylinder Escutcheon Lever Trim - Fail Safe
45ET-EU Cylinder Escutcheon Lever Trim - Fail Secure
1. PREPARE DOOR
A. Follow exit device instructions and template to prepare door and frame for
installation.
B. Follow lever trim instructions and special electric version of the trim template
(see document T-ED00372) to prepare door for installation.
i. The electric trim template identifies the location of a 1/2” diameter hole
through the door for wire transfer to exit device side of door. The wires
are then routed through the exit device, into the door raceway to power
transfer device (electric hinge).
ii. The wire transfer hole is handed, so be sure to use the correct location.
C. Door fabricator to provide a 3/8” diameter (minimum) raceway through door
to allow insertion of electrical wires running between exit device and power
transfer device (electric hinge). See “Wire Routing and Door Prep
Instructions” for 4500 Series Electric Exit Devices, document I-ED00367.
REV 3 Page 1 of 3
SOLENOID BRACKET
SOLENOID
PIVOT LEVER
LOCKING LINK
MOUNTING POST
27390028

4500 Series Electric Lever Trim
Electrical Supplemental Instructions
Grade 1
I-ED00370
REV 3 Page 2 of 3
2. PREPARE EXIT DEVICE
A. Remove four (4) screws from chassis cover and remove.
B. Separate chassis/push bar from device body by removing two (2) screws located on chassis.
C. After chassis/push bar has been removed from device body, insert cable assembly along the side of push bar. Make sure that
connector end is located on the chassis side.
D. After cable assembly has been routed on the side of the push bar, re-install the device body and secure with the two (2) screws.
CHASSIS
DEVICE BODY
PUSH BAR
3. ROUTE CABLE
RIM Device
A. Feed the connector on the trim control through the .500
diameter prep hole of door and through the slotted hole in
RIM device chassis.
B. Connect the cable assembly to the connector on the trim
and finish mounting the devices per the manufacturers
instructions.
Conceal and Surface Vertical Rod Devices
A. Feed the connector on the trim control through the .500
diameter prep hole of door and through the hole in surface
vertical rod chassis.
B. Connect the cable assembly to the connector on the trim
and finish mounting the devices per the manufacturers
instructions.
CHASSIS HOLE
27390028
SLOTTED CHASIS HOLE

4500 Series Electric Lever Trim
Electrical Supplemental Instructions
Grade 1
I-ED00370
REV 3 Page 3 of 3
4. SECURE WIRES
A. After the exit device and trim is mounted, secure the wires in the back of exit device body with the self-adhesive ty-wrap mount
and ty-wrap.
5. TERMINATE WIRE
A. Terminate wire connections with appropriate crimp splices or wire nuts.
NOTE: It is helpful to stagger terminations. This allows for easy insertion of wires through prep holes.
27390028
STRAIN
RELIEF