
2
Thank you for choosing this Hama product!
Take your time and read the following instructions
and information completely.Please keep these
instructions in asafe place for futurereference.
1. Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates arisk of electric shock from
touching uninsulated product parts that may carry
hazardous voltage.
Warning
This symbol is used to indicate safety instructions
or to draw your attention to specichazards
and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package contents
•charger
•these operating instructions
3. Safety instructions
•Protect the product from dirt, moistureand
overheating and use it in dry rooms only.
•Donot drop the product and do not expose it to any
major shocks.
•Donot operate the product outside the power limits
specied in the technical data.
•Donot modify the device in any way.Doing so voids
the warranty.
•Donot continue to operate the product if it is visibly
damaged.
•Use the product only for the intended purpose.
•Aswith all electrical products, this device should be
kept out of the reach of children.
•Donot use the product in the immediate vicinity of
heaters, other heat sources or in direct sunlight.
•Route all cables so thereisnorisk of tripping.
•Donot bend or crush the cable.
•Always pull directly on the plug when disconnecting
the cable, never on the cable itself.
•Dispose of packaging material immediately in
accordance with the locally applicable regulations.
•The product is intended only for use inside
buildings.
•Only use the article under moderate climatic
conditions.
•Donot use the product in areas in which electronic
products arenot permitted.
•Donot use the product in adamp environment
and avoid splashing water.
Risk of electric shock
•Donot open the device or continue to operate
it if it becomes damaged.
•Donot use the product if the
AC adapter,the adapter cable or the mains
cable aredamaged.
•Donot attempt to service or repair the product
yourself.Leave any and all service work to
qualied experts.
4. Operation
Note -mains voltage 100 -240 V
The charger is suitable for mains voltages of
100 -240 Vand thereforecan be used worldwide.
Please note that acountry-specicadapter may
be necessary.
Warning -connecting devices
•Beforeconnecting adevice, check whether it
can be adequately supplied with the charger's
current capacity.
•Ensurethat the power of the connected device
does not exceed 12W.
•Note the instructions in your device's operating
manual.
Warning
•Only operate the product from asocket that has
been approved for the device. The socket must
be installed close to the product and must be
easily accessible.
•Disconnect the product from the power supply
using the On/Off switch –ifthis is not available,
unplug the power cordfromthe socket.
GOperating instruction