HealTech Electronics iQSE-1 Instructions and recipes

QuickShifter easy
Supplementary Manual
Royal Enfield Himalayan ABS 2020- (iQSE-1 + QSH-F2B)
www.healtech-electronics.com 1/2
Secure the bike on a stand.
Remove the seats.
Remove the side covers from the airbox.
Remove the fuel tank.
Locate the fuel injector connector under
the fuel tank.
Connect the QSH connectors in-line with
the injector connectors.
(Make sure the QSH plugs marked with RED
square are connected, and leave the
unmarked coupler unused. You may connect
the male and female plugs of the unused
pair together or isolate with tape.)

QuickShifter easy
Supplementary Manual
Royal Enfield Himalayan ABS 2020- (iQSE-1 + QSH-F2B)
www.healtech-electronics.com 2/2
Connect the QSH Black wire terminal to
the battery negative terminal.
Mount the QSE sensor.
(Place the sensor in the rod as shown.
Tighten the nut by hand fully and then by a
1/4 turn using a wrench but maximum to
about 6 Nm.)
Typical position for the QuickShifter easy.
Secure the unit properly.