HealTech Electronics QuickShifter easy Instructions and recipes

QuickShifter easy
Supplementary Manual
Yamaha YZF-R125 2008-2013 (iQSE-1 + QSH-P2T)
www.healtech-electronics.com 1/3
Secure the bike on a stand.
Remove the seats.
Remove the black plastic covers below
the fuel tank.
Remove the fuel tank cover and remove
the fuel tank.
Remove the bellypan. 

Locate the ignition coil connectors under
the fuel tank.
Take off the Red/White terminal from
the coil.
Connect the Red/White terminal to the
QSH Red wire terminal.
Connect the QSH Green terminal to this
coil terminal.


QuickShifter easy
Supplementary Manual
Yamaha YZF-R125 2008-2013 (iQSE-1 + QSH-P2T)
www.healtech-electronics.com 2/3
Splice the QSH White wire to the Orange
wire of the coil by using the supplied red
wire tap connector.
Isolate the unused QSH Green wire
terminal with tape.
Connect the QSH Black wire terminal to
the battery negative terminal.
Mount the QSE sensor.
(Replace the bolt with the one supplied.
Tighten the bolt in this position by about 6
Nm. If you do not have torque wrench,
tighten the bolt until the shift arm is tight
on the gearbox shaft.)

QuickShifter easy
Supplementary Manual
Yamaha YZF-R125 2008-2013 (iQSE-1 + QSH-P2T)
www.healtech-electronics.com 3/3
Typical position for the QuickShifter easy.
Secure the unit properly.