HealTech Electronics iQSE-1 + QSH-P2T Instructions and recipes

www.healtech-electronics.com
S U P P L E M E N T A R Y M A N U A L
for iQSE-1 + QSH-P2T
PAGE 1/3
locate the ignition coil
terminals on the right side.
Kawasaki W800
2011-
Remove the seat.
Lift up or remove the
fuel tank.

www.healtech-electronics.com PAGE 2/3
Take off the red
terminal from the coil.
Connect the QSH green
terminal to this coil terminal.
Connect the red
terminal to the QSH red wire
terminal and secure with tape.
Isolate the unused QSH green
terminal with tape.
Splice the QSH white wire to
the black wire of the
coil by using the supplied
red wire tap connector.
(refet to the QSH-P2T instructions.)
S U P P L E M E N T A R Y M A N U A L
for iQSE-1 + QSH-P2T
Kawasaki W800
2011-
Connect QSH black wire
terminal to chassis ground.

www.healtech-electronics.com PAGE 3/3
Typical position for the
QuickShifter easy.
Secure the module properly.
Mount the QSE sensor.
(Replace the bolt with the one supplied.
Tighten the bolt in this position by
about 5-6 Nm.
If you do not have a torque wrench,
tighten the bolt until the
shift arm is tight on the gearbox shaft.
For different mounting options,
refer to the sensor install guide.)
S U P P L E M E N T A R Y M A N U A L
for iQSE-1 + QSH-P2T
Kawasaki W800
2011-