HealTech Electronics Kawasaki W800 2011 Instructions and recipes

QuickShifter easy
Supplementary Manual
Kawasaki W800 2011- (iQSE-1 + QSH-P2T)
www.healtech-electronics.com 1/3
Secure the bike on a stand.
Remove the seat and the side covers.
Remove the fuel tank.
Locate the ignition coil terminals under
the fuel tank.
Splice the QSH White wire to the Black
wire of the coil by using the supplied red
wire tap connector.

QuickShifter easy
Supplementary Manual
Kawasaki W800 2011- (iQSE-1 + QSH-P2T)
www.healtech-electronics.com 2/3
Take off the Red terminal from the coil.
Connect the QSH Green terminal to this
coil terminal.
Connect the Red terminal to the QSH Red
wire terminal.
Isolate the unused QSH Green terminal
with tape.
Connect the QSH Black wire terminal to
the battery negative terminal.
Mount the QSE sensor.
(Replace the bolt with the one supplied.
Place the conical washers at the two sides
of the sensor like this: (0). Tighten the bolt
in this position by about 6 Nm. If you do not
have torque wrench, tighten the bolt until
the shift arm is tight on the gearbox shaft.)

QuickShifter easy
Supplementary Manual
Kawasaki W800 2011- (iQSE-1 + QSH-P2T)
www.healtech-electronics.com 3/3
Typical position for the QuickShifter easy.
Secure the unit properly.