Hellermann Tyton tt230sm User manual

•The printer kit 556-00239 contains a TT230SM printer without
cutter.
•The printer kit 556-00256 contains the TT230SMC printer with
cutter.
•The cutter is required if printing and cutting HellermannTyton Solid
Colored Continuous Rolls.
•The printer with cutter should not be used for printing
HellermannTyton ShrinkTrak or Foam Nameplate labels.

Each kit will contain a printer, hard shell case, TagPrint
Pro 4.0 software and a ribbon. The 556-00256 kit will
also contain a white ribbon.

Ensure that you have received all items associated with your order.
This will include the following for both kits:
•TT230SM or TT230SMC thermal transfer printer.
•Caddy
•Cardboard ribbon core
•USB Stick
•USB cable
•Two pieces of Velcro
•Power supply
•Power cord
•Basic setup guide
•Tagprint Pro 4.0 label software
•A black ribbon **NOTE: The 556-00256 kit also contains a white ribbon.

After unpacking your printer, pull on the green release tabs on
both sides of the printer lid. This will release the lid and allow
it to open. Carefully remove the paper print head protector
and discard. Do not touch the print head.
Print Head
The printer shown in this guide is the TT230SMC with cutter.

12
3 4
Pull open ribbon cover as shown in step 1. Insert the ribbon core by aligning
the slot on the right side first and then pressing on the spring loaded spindle
lock to engage the left side of the core as shown in these photos.

12 3
4 5
Do not touch
Print head when
loading ribbon.
Turn gear counter clockwise
to tighten ribbon on core. Be
sure to wind the ribbon until
you only see BLACK and not
any of the blue leader.

Close ribbon cover.
Move guides apart.
They are not needed.
Check that the sensor is centered in
the printer. If not, move the sensor
to the center.
1
2
3

12
3 4
Apply Velcro strips as shown

Once Velcro is applied to both the caddy
and the printer bottom, attach the
caddy to the printer by mating the
Velcro strips as shown below.