Hidrotermal HIDRO-PW100 Manual

HIDRO-PW100
WALL MOUNTED UNDERWATER LED SWIMMING POOL LIGHT
INSTALLATION AND MAINTENANCE MANUAL
Please read this operation manual carefully and keep it for future reference.

1. Technical Parameters
□20W □35W □18W □24W
High Power LED
1. Only a licensed or certificated electrician or a qualified serviceman is allowed to install or
maintain this product.
2. Must be installed in accordance to the requirements of your government standard or local
authorities.
3. Before servicing the light, disconnect the power supply from the circuit breaker. Failure to
do so could result in serious injury, death and or damage to the property.
4. Never handle it with wet hands and feet.
5. This light is design for use only when fully submerged in water.
6. Never operate this light for more than 1 minute unless it is totally submerged in water.
7. All lights are required to be disconnected from the main electricity before any operation of
maintenance.
8. Maximum depth range for the light installation: 1-10 meter.
9. Maximum water temperature range for the light: -20℃-35℃
WARNING
Power: 12V / DC
SMD LED
Dimension: Φ295*70mm
Power:
□10W □12W
1

2. Installation
2.1 Preparing to Installation
2.2 Installation Notes
1. Consult the local Government Building Department to be certain that the pool's electrical
system meets all applicable requirements.
2. This light is designed to be used in new pools and/or pools with existing same swimming
lights that need replacement.
3. This light can be installed in both concrete pool and vinyl pool.
4. Use only good quality stainless steel screws or screws provided along with the light.
5. The light must be used or operated while fully submerged underwater only. Never switch on
the light if it is not underwater.
1. Make sure to install the niche/housing on a vertical wall of the pool.
2. Make sure the top of the light should be at least 450mm below normal water surface.
3. Reserve at least 150mm long backup wire wrapping on the back of the light, for the
convenience of replacing.
4. The junction box or the 12V low voltage transformer, should be located at least 300mm
above the water surface, at least 200mm above the ground, and at least 1200mm from the
edge of the pool.
5. The light fixture and all metal parts that are within 250cm of the pool must be properly
protected with non-ductile materials and that the connections must be waterproof.
6. To achieve synchronization, make sure all the lights are installed correctly on model and
characteristics as the one being replaced.
2

5.Warranty
3
3. RGB Light Color Control Operation for Light with DC Input
The DC light with 4 lines, they should connect to Hidrotermal DC controllers: Hidro Sync,
WiFi-103, Hidro H3 and Repeater Hidro-LT3060.
4. Maintenance and Replacement
1. There is no maintenance required for this light. It is designed to be used only once,
meaning that replacement is necessary if it becomes defective. The repairing is impossible.
2. Before servicing the light, always disconnect power at the circuit breaker to it. Make sure
there is NO voltage supplied to the light.
3. To replace the light, unfasten it from the bracket. Make sure the new light is the same
switch.
1. The manufacturer warrants this led underwater light against defect in materials and
workmanship for a period of two (2) years from the date of purchase.
2. This warranty is limited to the first retail purchaser, it is not transferable, and does not
apply to products that have been moved from their original installation sites. This warranty
does not cover failures or malfunctions from improper installation and/or operation.
3. The manufacturer is not responsible in any circumstances for assembly, installation or
start-up of any electric components which have been inserted or handled at locations other
than its own premises.
4. The liability of the manufacturer shall not exceed the repair or replacement of defective
parts. It specifically excludes liability for direct, incidental or consequential damages.