Hobby King Mellizo-50e User manual

AIRCRAFT SPECIFICATIONS：
Wing Span: 1480mm/58.26"
Top Wing Area: 31.51 Sqdm/ 488.47 Sqin
Bottom WingArea: 31.48 Sqdm/ 487.89 Sqin
Lenght:1592mm/62.68in
Weight: 3300/3400g RTF less battery
RECOMMENDED EQUIPMENT：
Motor: 50e size 300~400KV
ESC: 60~80amp
Radio: 6ch
Battery: 6cell 3800cell to 4500mah Lipoly.
Prop: 16x12e ~ 17x10e
Warning! This model is not a toy.
It is designed for maximum performance. Please seek
advice if one is not familiar with this kind of electric
powered precision model.
Operating this model without prior preparation may cause
in juries.
Remember, safety is the most important thing. Always keep
this instruction manual at hand for quick reference.

1.Wing
Wings Part List Apply instant glue
Cut the covering away for installing
the
bottom aileron servo
Cut the covering
away
for
passing
through the servo extension line
Pass through the servo extension line Install bottom aileron’s servo

Fix the bottom aileron horn Complete the bottom aileron servo’s
installing and install the top aileron
servo according to the same method
Fix the bottom wing Cut the covering away for fixing the
Wing support
Fix the bottom wing support with
instant glue Fix the wing support with 10pcs M3*15 cross head screw,10pcs M3 nut and
20pcs Φ3*Φ8 washer

Fix the top wing support with instant
glue Cut a hole for pass through the top aileron servo extension line
Fix the top wing support complete wing part’s install
2.Stabilizer/Vertical/Tail Wheel
Stabilizer/Vertical
Tail Wheel Part List
Cut away the cover film

Cut away the wood and drill diameter
2.5mm hole for fix the elevator linkage rod
Fix the linkage rod with epoxy glue
Apply instant glue Before fix the horizontal you must
pass through the elevator first
Fix the horizontal with instant glue Apply instant glue

Install the tail wheel and bend the steel
wire
Fix the tail wheel
Apply instant glue Cut away the wood and drill a diameter 2mm
hole for fix the tail wheel steel wire
Fi
x
the
tail
wheel
steel
wire
with
epoxy glue
Fix the elevator servo

Fix the elevator’s horn Complete the elevator servo system’
s
installing
Fix the rudder servo Fix the rudder’s horn
Complete the rudder servo system’
s
installing

3.Main Landing Wheel
Main Landing Wheel Part List Cut this part away
Fix the plywood with epoxy glue Cut this part away
The shaft passes through the wheel and
the main landing chassis. Then fixed
using M4 skidproof nut
Put the complete wheel parts into the
wheel cowling

Locking the skidproof nut Locking the Wheelchocks
Fix the main landing set
4.Canopy/ Motor Mounting
Canopy Part List Fix the plywood with instant glue

Fix the canopy Put the motor into fuselage
Fix the motor Fix the screw propeller
Fix the spinner Canopy Part List