Hogtunes SG RM Grill User manual

HOGTUNES
Audio Solutions For The Great American Cruiser
Designed and Engineered in North America
SG RM Grill
Installation Manual
Rev 1.1
The Grills In This Kit Are Made
Specifically For Rushmore
Platform Street Glides
And Ultra Classics.

Congratulations and Thank-you for your purchase of Hogtunes SG RM Grill
for “Rushmore” platform bikes! If you have any questions or concerns,
we are here to help. Email [email protected] or call us during regular
business hours (EST) at 705-719-6361. If you still need help, then please
consider a professional installation by your dealer.
Grill Installation Instructions:
Step #1: Make sure your ignition switch stays in the “OFF” position.
Remove your outer fairing/headlamp assembly and set aside. Refer to a
service manual if you need help with this. NOTE: Placing a towel on the
front fender can help prevent scratches or “dings” from dropped tools
or fasteners, etc.
Step#2: Speaker Cabinet Removal: On the brake side speaker cabinet,
carefully remove the cable going into the power port/cigarette lighter
assembly. If your bike has the CB module (mounted “sideways” on the
clutch side cabinet) undo the antenna cable and main harness. The CB
Module will stay attached to the clutch side cabinet when removed. Undo
the speaker wire plugs going into each cabinet (pink/pink black wires).
NOTE: We STRONGLY suggest completing the grill swap on one side and
then moving to other side! Figure 1.1 and 1.2 (below) have arrows that
point to the factory fasteners that will be removed to allow the cabinets
to come out of the bike. Although the Brake Side is shown below,
fastener locations are common for both brake and clutch side cabinets.
Figure 1.1 Side View of
Brake side cabinet
Figure 1.2 Back View of
Brake side cabinet

Step #3: Installing The Grill: Undo the 3 screws that attach the factory
grill to the inner fairing and put it aside. The Hogtunes grill is installed
using the 3 factory screws just removed. In the Hogtunes grill, you will
see two holes and one “keyhole” where the screws go through and
into the fairing. The keyhole in the Hogtunes grill needs to be oriented
so it is closest to the radio on each side for proper fitment! With the
new grill in place the cabinet can be re-installed to the bike.
Repeat Step #3 for the second cabinet. Plug the factory speaker wires
back into each cabinet’s speaker wires . Make sure to plug the power
cable back into the power port/cigarette lighter assembly on the brake
side. If your bike has the CB module, make sure to re-install the
antenna cable and main harness. Re-install your fairing and windshield
and you are done!
Customizing the Grills:
You will have noticed that your new grills are pretty thick. The main
reason for this is so the grills would not likely warp during most
finishing processes such as polishing, powdercoating, chroming etc.
The grills in this kit look great the way they are, but custom finishing
them is an easy way to customize the look of your inner fairing!
See your dealer or painter to discuss options right for you.
Harley-Davidson, Electra Glide, Street Glide, Ultra Classic, are Trademarks, and/or Registered
Trademarks of Harley-Davidson, Inc., Milwaukee, Wisconsin, USA, and if Used or Implied are
for Reference Only. There is No Affiliation Between Harley-Davidson, Inc., and Hogtunes Inc.

www.hogtunes.com
Any audio system can be a distraction to the rider
and/or passenger. Please use caution when
playing your stereo, especially in traffic.