Holman 40203 Manual

20220317R1 Date: __________
Instruction Guide
40203
Holman
Rancho Cordova, CA 95742
800-343-7486
InstallationSuppor[email protected]

Instructions –40203
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 1
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT.*
Warning
Always check for wires, fuel tanks and lines, brake lines and other important
vehicle functionality items prior to drilling and installing all products.
BE SURE ALL TANKS OR GAS BOTTLES ARE SECURE BEFORE
TRANSPORTING.
Tools Needed
7/16” Socket and
Wrench
7/16” Box Wrench
9/32” Drill Bit
Drill
Table of Contents
Parts..................................................................................................................................................2
Hardware...........................................................................................................................................2
Step 1 –Assemble Shelf ...................................................................................................................3
Step 2 –Install Shelf..........................................................................................................................3
Before You Begin
Read all instructions prior to assembling or installing any Holman product.
Always locate your installation locations prior to performing any work.
Be sure to have adjustable bottle restraint installed prior to installing shelf.
ENSURE SAFETY WHILE INSTALLING OR DRILLING INTO VEHICLE.

Instructions –40203
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 2
Parts
Hardware

Instructions –40203
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 3
DO NOT EXCEED MANUFACTURERS WEIGHT CAPACITY FOR ROOF.
Step 1 –Assemble Shelf
Using four 1/4” x 1/2” carriage bolts and four 1/4” flanged lock nuts, attach shelf to gussets. Be sure
theflanges on gussets are directed inward.
Tighten but allow movement.
Step 2 –Install Shelf
Place shelf against installation
surface. Be sure shelf is aligned
andsquare to the bottle restraint
bracket.
The shelf can be installed at any
position on bottle restraint.
Be sureshelf is in correct
location and bottle is able to be
properly secured prior to drilling
through installation surface.
Bottle restraint shown here without
securing straps for clarity.

Instructions –40203
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 4
Mark on installation surface the location
ofthe holes in the gussets.
Using a 9/32” drill bit, drill through
theinstallation surface.
Using four 1/4” x 5/8” hex bolts, four 1/4” lock washers, and four 1/4” flat washers, bolt
throughinstallation surface into press nuts on gussets.
Tighten all hardware.
GO BACK AND TIGHTEN ALL HARDWARE.
INSTALLATION AND ASSEMBLY ARE COMPLETE.
MARK
MARK
MARK
MARK