HOMCOM 700-088 User manual

700-088
MASSAGE CHAIR
C000000

Congratulations on having purchased our massage
armchair. Please read this instruction manual carefully
before using it (especially the points regarding safety) in
order to use the armchair correctly. Keep this manual
somewhere close by so that you can always refer to it if
needed.
Safety Rules.......................................................................3
The armchair parts...........................................................4
Functional Description of Massager ...........................5
Massage Areas................................................................6
Resting and Close the recliner.......................................6
Principal Characteristics..................................................7
Assembly Instructions.......................................................8
Troubleshooting................................................................9

SAFETY RULES
•Never set the armchair in wet/damp areas or where dust can
accumulate as these could cause an electrical fault or a
mechanical dysfunction.
• Never use the massage armchair inside your home if the room
temperature is over 40°C.
•Never place the armchair near a heat source (oven, chimney, etc...)
or indirect sunlight.
Do Not use the armchair if:
•The armchair is wet
•Your hands are wet
•Only clean the chair with a dry cloth
•It's advisable not to use the massage armchair for more than 30
minutes at a time and that you drink 2 glasses of water after using it.
Situations where you should not use the massage armchair:
Switch the armchair's massage system off if it gets wet or seems not to be
working properly,if any part of the armchar is damaged or
malfunctioning,if any part of the armchair appears to be damaged or
wiring is exposed,if you feel unwell or feel any pain during the massage,or
if ther has been a general electrical fault.
When the massage system of the armchair is not in use:
•Make sure it is switched off
•Unplug the armchαir’s massage system from the mains when you are
not going to use it for long periods of tim
•Keep the massage armchair clean and dry place.

Disassembling the massage armchair:
• Do not remove the back of the armchair .
• Do not try to disassemble or repair the armchair yourself.
Correct way to handle the mαins plug:
•Check that you have the right voltage.
• Never use force on the cable or plug.
• Never pull the cable with wet hands.
•When removing the plug, hold the plug itself, do not pull on
the cable.
•Do not use the armchair massage system if either the cable or
the plug are damaged.
The Parts forming the massage armchair:
1)Back
2)Armrests
3)Seat
4)Footrest
5)Control unit
1
2
3
4
5

Functional Description of Massager
I. Graphic presentation of Controller
1. POWER: turn on/off selection key
2. HEAT: heating on/off key
3.INTENSITY: High/Low
4. MODE: working mode
5. BACK: back massage
6.LUMBAR: lumbar massage function
7.THIGH: thigh massage function selection key
8.LEG: leg massage function selection key
9. TIMER: set working time key
II. Operating Instructions
•Insert the power into the DC socket
•Press the POWER key to start the unit, when the unit will
•enter the first mode to run for 15min
•in the medium step, with all the corresponding indicators
•illuminated.
•Press the HEAT key to select the heating function ON ,Press
•the key again switch off the heating
•function.
•Press the TIMER key, the unit’s control time will switch
•between 15min, 30min and 60min.
•Press the FUNCTION key to select different working modes
•(PULSE,PRESS,WAVE,AUTO,NORMAL)
•Press the INTENSITY key to select the high and low the
•intensity of vibration.
•Press the BACK, LUMBAR and THIGH key will to massage the
•different places of the body

Massage Areas
• The arm chair comes in two parts that are easily
assembled and easy to clean.
•It has 1 hand control unit for controlling the
massage functions.
-8 vibratin massage points,heating function in
the lumbar region and 2 levels of intensity.
-9 different types of massage.
Resting Function&Close the Recliner
Pull the switch inside the right armrest as shown and then recline
the chair freely.
Use your legs press hardly on the chair footrest to close the
Recliner.

Principal characteristics of the armchair
1) Components:
•Back, seat,armrest,footrest,1 control unit and the power supply.
2) Functions:
•Reclining back, extendible footrest, lumbar region heating
function, massage function and elevating function.
3) Usage:
•Indoors, avoid high temperatures and wet or damp areas.
Precaution:
•Never sit on the hand control or place heavy objects on top of it
•Do not drop the hand control on the floor.
•Do not tug on the electric able.
•Do not use the hand control with wet fingers.
•Do not press or touch the buttons with sharp objects.
•Never unplug the hand control unit wihout first turning the
current off.
•The massage armchair should left to rest for 30 minutes after it has
been used for 30 minutes.
Effecs and benefits of the massage:
•Alleviates muscular fatigue.

Assembly Instructions:
1)Position the Arms so that
they fits into the seat,you
will hear a “click” when
they are in place.
2) Position the Back(refer to point
1） Connect Recliner supply cable
pins.Fit the pins properly in the
manner shown in the image. Do
not force them,they only have one
correct position.
3)The pins must be connected
correctly. 4)Pull the switch inside the right
armrest as shown and then
recline the chair freely.

Troubleshooting:
If the armchair is not working, check the following chart.
Make sure you turn the power off and unplug from the mains.
If you have any questions, please contact us. Do not
disassemble or repair any part of the armchair yourself.