Home Styles 88 5569 30 User manual

88 5569 30
Dining Table
Tools recommended for assembly : Level
Home Styles Consumer Assistance : www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Hardware List
Part List
Tools required for assembly : Slotted screwdriver
IMPORTANT NOTE
This product is made of sturdy, high quality aluminum
and will provide years of enjoyment. Do not use power tools
to assemble and only tighten bolts until they are snug.
Over tightening can cause damage to the aluminum.
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occurring to the parts.
We have taken great care in the design of this product and
request that you carefully and strictly follow our assembly
instructions to ensure a completed product as it was designed.
A.
Top
1 pc.
B.
Leg
4 pcs.
C.
Stretcher
1 pc.
Spring Washer (large)
8 pcs. (+1 extra)
Flat Washer (large)
8 pcs. (+1 extra)
Key Wrench
1 pc.
Nut (large)
8 pcs. (+1 extra)
Nut Cap (large)
8 pcs. (+1 extra)
Cover
1 pc.
M6x50
Head Cap Bolt
8 pcs. (+1 extra)
Hex Wrench
1 pc.
M x408
Bolt
8 pcs. (+1 extra)
Flat Washer
16 pcs. (+1 extra)
Spring Washer
8 pcs. (+1 extra)
Nut
8 pcs. (+1 extra)
Nut Cap
8 pcs. (+1 extra)

Assembly Instructions 2/2
IMPORTANT
* Please keep Key Wrench in a safe place as you may need to tighten up the Nuts in the future.
* Use a soft cloth between these parts and the floor.
* Do not use power tools to assemble and do not over tighten the bolts and nuts.
* Do not tighten up all the bolts and nuts until each part is properly assembled.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
STEP 1
Attach Legs (B) to Stretcher (C) with
Head Cap Bolts, Flat Washers,
Spring Washers, Nuts and Nut Caps.
(See Figure 1)
Figure 1
STEP 3
Turn the unit over to its' upright position.
Cover the umbrella hole with Cover.
To level the unit, adjust the adjustable
levelers on the bottom of the legs.
(See Figure 4)
Figure 2
STEP 2
Place Top (A) upside down on a soft cloth.
Insert Bolts into the pre-drilled holes of Top (A).
(See Figure 2)
Attach unit to Top (A) with
Flat Washers (large),
Spring Washers (large),
Nuts (large) and
Nut Caps (large).
(See Figure 3)
Figure 3
Nut Cap (large)
Flat Washer (large)
Spring Washer (large)
Nut (large)
Cover
A
Bolt
B B
B
B
C
Flat Washer
Spring Washer
Nut
Nut Cap
Head Cap Bolt
Figure 4
Flat Washer