Home Styles 20 08101 0022 User manual

Part List
IMPORTANT
20 08101 0022
Console Table
Carefully remove all the parts from the carton and
place them individually on a soft cloth to prevent
scratches or other damage.
Carefully and strictly follow these assembly instructions
to ensure a completed product as designed.
Do not use power tools above 8 volts to assemble.
Home Styles Customer Service: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Care Instructions
The concrete top is made of natural stone materials with naturally occurring
fissures and cavities. A sealer has been applied to the concrete to reduce the
absorption of liquids. Even with sealer applied, liquids can absorb into the
concrete causing permanent stains. Never allow liquids to remain on the top.
B.
Side Frame
2 pcs.
C.
Stretcher
2 pcs.
D.
Stretcher
1 pc.
A.
Top
1 pc.
Hardware List
Tool(s) required for assembly: Level
M6x15
Head Cap Bolt
18 pcs. (+1 extra)
Hex Wrench
1 pc.
Flat Washer
6 pcs. (+1 extra)
Small Hex Wrench
1 pc.

Assembly Instructions 2/4
IMPORTANT
Use a soft cloth between these parts and the floor.
Do not use power tools above 8 volts to assemble.
Do not tighten all the bolts until each part is properly assembled.
The unit must be level to work properly. Use the included adjustable levelers to level.
Keep Hex Wrench as the bolts may need to be tightened in the future.
Figure 1
STEP 1
Attach Stretchers (C) and (D) to Side Frame (B) with Head Cap Bolts, tightening bolts only halfway.
(See Figure 1)
Attach Side Frame (B) to unit with Head Cap Bolts, tightening bolts only halfway.
B
B
D
C
C
Head Cap Bolt

Assembly Instructions 3/4
STEP 3
Turn unit over to its upright
position.
Level unit by adjusting the
adjustable levelers on bottom
of unit. (See Figure 2)
Figure 2
A
Head Cap Bolt
STEP 2
Place Top (A) upside down
on a soft cloth.
Attach unit to Top (A)
with Flat Washers and
Head Cap Bolts, tightening
bolts only halfway.
Tighten all Head Cap Bolts
used in Steps 1 and 2.
Flat Washer

Assembly Instructions 4/4
Hardware List
STEP 4
Place unit at desired location.
Drill a 3/8” hole in wall in-line with
pre-drilled hole at top of unit.
Move unit.
Insert Anchor into the wall hole
and attach Bracket with Wall Screw.
Attach Bracket at pre-drilled hole
at top of unit with Machine Screw.
Move unit back into place.
Slide Tip-over Restraint through
Bracket on wall and Bracket on unit.
(See Figure 3)
Put tie end of Tip-over Restraint into lock
end of Tip-over Restraint and pull until tight.
M3.5x40
Wall Screw
1 pc. (+1 extra)
IMPORTANT
To help reduce the risk of the unit tipping over, the Tip-over Restraint must be installed following these instructions exactly.
M4x16
Machine Screw
1 pc. (+1 extra)
Anchor
1 pc. (+1 extra)
Bracket
2 pcs. (+1 extra)
Tip-over Restraint
1 pc. (+1 extra)
Drill 3/8” hole in wall
Pre-drilled hole at top of unit.
Figure 3
Anchor in wall
3/8” wall hole
Tip-over
Restraint
Machine Screw
Wall Screw Pre-drilled hole
at top of unit
Bracket
on wall
Tie end
Lock end
Bracket at
top of unit

NEVER
use glass cleaners on
finished furniture. Ammonia
chemically attacks the finish.
allow liquids to remain on furniture.
Absorption causes parts to warp
and split and finishes to delaminate.
NEVER
CARE INSTRUCTIONS
Do not use rubber
based placemats.
PREVENT
DISCOLORING
Do not use commercial
waxes and polishes.
PREVENT
YELLOWING
Do not place hot
objects on surface.
PREVENT
FINISH DAMAGE
Do not write
directly on surface.
PREVENT
MARKING
Do not use power tools
above 8 volts to assemble.
PREVENT
CRACKING
Do not place
in direct sunlight.
PREVENT
FADING
with a soft cloth moistened
in lukewarm soap and water.
Buff with a dry clean cloth.
CLEAN
Home Styles will provide replacements free of charge for missing or damaged hardware or parts within 30 days of
purchase. Digital images of the defective parts may be required. If the product was not purchased from an authorized
retail affiliate, Home Styles is under no obligation to provide replacement parts. Parts are not available for fully assembled
items nor are parts available for sale. Replacements for missing or damaged hardware or parts may be requested at:
www.homestyles-furniture.com/customer-service/replacement-parts
Home Styles Customer Service: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319