Home Styles 88 5555 33 User manual

Tools required for assembly : Slotted screwdriver, Level
Part List
88 5555 33
Home Styles Consumer Assistance : www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
IMPORTANT NOTE
This product is made of sturdy, high quality aluminum
and will provide years of enjoyment. Do not use power tools
to assemble and only tighten bolts until they are snug.
Over tightening can cause damage to the aluminum.
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occurring to the parts.
We have taken great care in the design of this product and
request that you carefully and strictly follow our assembly
instructions to ensure a completed product as it was designed.
Oval Dining Table
Key Wrench
1 pc.
M8x35
Bolt
8 pcs.(+1 extra)
Flat Washer
16 pcs.(+1 extra)
Spring Washer
16 pcs.(+1 extra)
M8
Nut
16 pcs.(+1 extra)
Nut Cap
16 pcs.(+1 extra)
A.
Top
1 pc.
B.
Leg
4 pcs.
C.
Stretcher
1 pc.
Hardware List

Figure 1
STEP 3
Turn table over to its’ upright position.
To level the table, adjust the adjustable
levelers on the bottom of legs.
(See Figure 2)
Figure 2
B
B
BB
C
STEP 1
Attach Legs (B) to Stretcher (C)
with Flat Washers, Spring Washers and
Nuts, tightening the nuts only half way.
Nut Cap
Nut
Flat Washer
Spring Washer
A
STEP 2
Place Top (A)
upside down on a soft cloth.
Insert all Bolts into the pre-drilled holes
of Top (A). (See Figure 1)
Attach unit to Top (A)
with Flat Washers, Spring Washers
and Nuts, tightening the nuts only
half way.
Tighten all Nuts used in Steps 1 and 2 with Key Wrench.
Cover all Nuts with Nut Caps.
Nut Cap
Nut
Flat Washer
Spring Washer
Bolt
IMPORTANT
* Please keep Key Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Use a soft cloth between these parts and the floor.
* Do not tighten up all the nuts until each part is properly assembled.
* Do not use power tools to assemble and do not over tighten the bolts and nuts.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
Assembly Instructions 2/2