Honeywell Silent Knight 5860 Manual

P/N 151042 Rev C
ECN 14-0358
5860 Remote Fire Annunciator
Installation Quick Reference
The optional Model 5860 Remote Annunciator, as shown
in Figure 1, can be surface or flush mounted.
Figure 1: Model 5860 Remote Annunciator
5860 installation involves the following steps:
1. Make sure power is off at the panel.
2. Annunciator is assembled at the factory. Disassemble
as needed.
3. Mount annunciator.
4. Wire annunciator to the panel. See
5. Use the DIP switches on the back of the 5860 to set
the annunciator ID. See Figure 4.
Figure 2: 5860 Parts
Wiring Connections
Wire the 5860 to the FACP as Shown in Figure 3.
Figure 3: SBUS Connections
Figure 4: DIP Switch settings
Product Max. 5860s
Allowed
For more
Information see
Manual PN
5820XL/5820XL-EVS 12 LS10061-001SK-E
5808 12 151274-L8
5700 8 151295

Model 5860 Installation Instructions
2P/N 151042 Rev C
ECN 14-0358
Mounting the 5860
This section describes mounting the remote annunciator.
The annunciator can be flush- or surface-mounted.
Figure 5: Annunciator Dimensions
Surface Mounting
The Model 5860TG (gray) and 5860TR (red) trim ring kits
are available for use when surface mounting.
Figure 6: Surface Mounting
Flush Mounting
This section of the manual describes flush mounting.
Follow these steps to flush mount the 5860:
Figure 7: Flush Mounting
Mounting Holes