Honeywell TWINDOW HW-628 User manual

OWNER'S MANUAL
TEMPERATURECONTROL
LOWHIGH
•
•
•
•
SUPERHIGH
OFFLOW
FRESH
AIR
EXHAUST
•
•
•
•
SUPERHIGH
OFFLOW
FRESH
AIR
EXHAUST
SPEEDSPEED
TWINDOW®
TWIN WINDOW FAN
Model HW-628
HW-628 OM_eng 09/28/01 10:34 AM Page 1

IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE SAFETY
INSTRUCTIONS BEFORE USING THIS FAN
When using electrical
appliances, basic precautions
should always be followed to
reduce the risk of fire, electric
shock, and injury to persons,
including the following:
1. Use this fan only as described in this
manual. Other use not recommended
may cause fire, electric shock or injury
to persons.
2. This product is intended for household
use ONLY and not for commercial,
industrial or outdoor use.
3. To protect against electric shock, DO
NOT immerse unit, plug or cord in
water or spray with liquids.
4. This appliance has a polarized plug
(one blade is wider than the other). To
reduce the risk of shock, this plug is
intended to fit only one way in a
polarized outlet. If the plug does not fit
fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician. DO NOT attempt to defeat
this safety feature.
5. Close supervision is necessary when
any appliance is used by or near
children.
6. Turn the fan to the OFF position and
unplug the fan from the outlet when not
in use, when moving the fan from one
location to another and before
cleaning.
7. To disconnect the fan, first turn control
to the OFF position, grip the plug and
pull it from the wall outlet. Never pull
by the cord.
8. Do not operate the fan in the presence
of explosive and/or flammable fumes.
9. Do not place the fan or any parts near
an open flame, cooking or other
heating appliance.
10.Do not operate the fan with a damaged
cord or plug or if the product
malfunctions, is dropped or damaged
in any manner (see warranty).
11.Avoid contact with moving fan parts.
12.The use of attachments not
recommended by the manufacturer may
be hazardous.
13.Place the fan on a dry level surface.
14.Do not hang or mount fan on a wall or
ceiling.
15.Do not operate if the fan housing is
removed or damaged.
16.A loose fit between the AC outlet
(receptacle) and plug may cause
overheating and a distortion of the
plug. Contact a qualified electrician to
replace loose or worn outlet.
17.This fan is rated for use as a window
fan, however, we recommend that
during rain, the fan be removed from
the window.
WARNING: To Reduce The Risk of
Fire or Electric Shock, Do Not Use
This Fan With Any Solid-State Speed
Control Device.
HW-628 OM_eng 09/28/01 10:34 AM Page 2

Your fan comes fully assembled and ready for installation. Casement and sliding
windows require a mounting bracket for installation which can be found in the
hardware packet provided.
Your fan has been designed to fit double hung, casement or sliding windows with
minimum openings of 23” wide x 12” high (58cm X 30cm). Casement or sliding
windows require minimum openings of 12” x 23” high (30cm X 58cm).
• Open your window at least 12” high (30cm).
• Turn the fan so that the front faces you. With the power cord hanging inside
your room, position the lower edge of the fan in the window. Lower the
window to the top of the fan. NOTE: Be sure the window is seated
between the window guides protruding from the top of the fan
(Fig. 1).
• Pull out each side panel until the space on the sides of the fan are fully blocked.
• To push the side panels back into the fan, pull out each tab on the back
side of the fan (Fig. 2). In this “pulled-out” position you can easily slide the
side panels back into the fan. The tabs should then be returned to the normal
position to secure the side panels in place.
WARNING: To prevent personal injury and/or damage to the fan,
never lean or push on fan while it is sealed in the window or during
operation. Do not lift the window while the fan is operating. Be sure
that the fan is fully secured in the window at all times.
TAB
Fig. 2
INSTALLATION INSTRUCTIONS
DOUBLE HUNG WINDOWS
WINDOW
GUIDE
Fig. 1
HW-628 OM_eng 09/28/01 10:34 AM Page 3

•Remove the four “shoulder screws”supplied from the hardware packet.
•Screw two of the four shoulder screws into the holes on the bottom back of the
fan and two into the holes on the bottom front of the fan.
•Remove the mounting bracket from the kit provided.
•Temporarily hook the mounting bracket over the four screws to hold the bracket
in place (Fig. 3).
•Choose a suitable mounting location on the window frame where the fan can
be positioned to direct airflow through the open window. Mark the location of
the bracket with a pencil for placement. NOTE: Since the mounting
bracket will remain attached to the window frame at the marked
location, be sure that the bracket is positioned in a manner that
will allow the window to be closed when the fan is removed.
•Unhook the bracket from the fan. Using the wood screws provided in the
hardware packet, mount the bracket into the frame at the marked location
(Fig. 4). The fan can be mounted onto the bracket within the window and is
ready for use (Fig. 5).
•In rare instances during CASEMENT window installation, your window screen
may not fit in its original position. In that event, it may become necessary to
use an “alternate bracket”will be provided free of charge. This alternate
bracket will enable you to use your window screen in its original position.
Please refer to the PARTS AVAILABLE section of this instruction manual.
SCREWS
BRACKET
Fig. 3
WINDOW
FRAME
WOOD
SCREWS
Fig. 4
BRACKET
TEMPERATURECONTROL
LOW HIGH
•
•
•
•
SUPER HIGH
OFF LOW
FRESH
AIR
EXHAUST
SPEED
Fig. 5
CASEMENT OR SLIDING WINDOWS
HW-628 OM_eng 09/28/01 10:34 AM Page 4

•Plug the fan into a polarized 120 Volt AC wall outlet.
•Turn the Thermostat Control to its highest setting (fully
clockwise).
•Set the fan to either the FRESH AIR or EXHAUST
mode by moving the FRESH AIR/EXHAUST switch up
or down (Fig. 6). The FRESH AIR setting draws in air
from the outside. The EXHAUST setting pulls indoor
air out of the room. NOTE: Do not switch the
fan from FRESH AIR to EXHAUST while the
fan is on.
•Adjust the SPEED control of each fan to either SUPER, HIGH or LOW.
•When a comfortable room temperature has been reached, slowly turn the
thermostat control COUNTER-CLOCKWISE until the fan stops. The thermostat
will now turn the fan ON and OFF to maintain this comfort setting.
•The front air grilles can be manually rotated to change the direction of the air
flow.
TEMPERATURE CONTROL
LOWHIGH
•
•
•
•
SUPER HIGH
OFF LOW
FRESH
AIR
EXHAUST
•
•
•
•
SUPER HIGH
OFF LOW
FRESH
AIR
EXHAUST
SPEEDSPEED
Fig. 6
OPERATION
•Turn fan off and unplug the fan before cleaning.
•The fan grilles are removable for cleaning by gently prying the grille from fan
using a small screwdriver on the rim of the grille. (DO NOT INSERT
SCREWDRIVER INTO THE GRILLE).
•Use only a soft, damp cloth to gently wipe the fan clean.
•DO NOT immerse the fan in water and never allow water to enter the motor
housing.
•DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
•For storage, clean the fan as instructed and store it in its original box. Or,
cover with plastic to protect it from dust. Store your fan in a clean, dry place.
CLEANING AND STORAGE
HW-628 OM_eng 09/28/01 10:34 AM Page 5

Item Part No. Price
Mounting Bracket and Hardware Kit DW-628-1 $5.00 US/$7.50 CAN
Alternate Bracket (casement windows only) DW-628-2 No Charge
To order parts send your request to Honeywell Consumer Relations. Be sure to
include your fan model number, part no. and quantity desired. Make your check
or money order payable to Honeywell and please include $4.50 US/$7.00 CAN
for shipping and handling. For your convenience, we also accept VISA and
MASTERCARD orders by telephone. MASSACHUSETTS RESIDENTS PLEASE
ADD 5% SALES TAX.
NOTE: Honeywell cannot ship to P.O. Box Numbers.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE RETURN THE FAN TO
THE ORIGINAL PLACE OF PURCHASE OR SEE YOUR WARRANTY. DO
NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF. DOING
SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE FAN
OR PERSONAL INJURY.
IF YOU HAVE ANY QUESTIONS REGARDING THIS FAN, PLEASE CALL
OR WRITE:
HONEYWELL CONSUMER PRODUCTS
CONSUMER RELATIONS DEPARTMENT
TOLL FREE:
1-800--332-1110
Mail questions or comments to:
HONEYWELL CONSUMER PRODUCTS
Consumer Relations Dept.
250 Turnpike Road
Southborough, MA 01772
USA
Please be sure to specify model number.
Thank you for purchasing a Honeywell fan.
Please visit us at www.honeywell.com/yourhome
REPLACEMENT PARTS AVAILABLE/CONSUMER RELATIONS
HW-628 OM_eng 09/28/01 10:34 AM Page 6

©2001 All rights reserved. Honeywell.
P/N: 035-02389-000 Rev 0
Artwork: 043-50211-000 Date 09/01
You should first read all
instructions before
attempting to use this
product.
The enclosed Customer
Response card should be
filled out and returned
within 10 days of
purchase.
A. This 5 year limited
warranty applies to repair
or replacement of product
found to be defective in
material or workmanship.
This warranty does not
apply to damage resulting
from commercial,
abusive, unreasonable
use or supplemental
damage. Defects that are
the result of normal wear
and tear will not be
considered
manufacturing defects
under this warranty.
HONEYWELL IS NOT
LIABLE FOR INCIDENTAL
OR CONSEQUENTIAL
DAMAGES OF ANY
NATURE. ANY IMPLIED
WARRANTY OF
MERCHANTABILITY OR
FITNESS FOR A
PARTICULAR PURPOSE
ON THIS PRODUCT IS
LIMITED IN DURATION
TO THE DURATION OF
THIS WARRANTY.
Some jurisdictions do not
allow the exclusion or
limitation of incidental or
consequential damages
or limitations on how long
an implied warranty lasts,
so the above limitations
or exclusions may not
apply to you. This
warranty gives you
specific legal rights, and
you also may have other
rights which vary from
jurisdiction to jurisdiction.
This warranty applies
only to the original
purchaser of this product
from the original date of
purchase.
B. At its option, Honeywell
will repair or replace this
product if it is found to be
defective in material or
workmanship. Defective
product should be
returned to the place of
purchase in accordance
with store policy.
Thereafter, while within
the warranty period
defective product may be
returned to Honeywell.
C. This warranty does not
cover damage resulting
from any unauthorized
attempts to repair or from
any use not in
accordance with the
instruction manual.
D. Return defective
product to Honeywell
Consumer Products with
a brief description of the
problem. Include proof
of purchase and a $10
US/$14.70 CAN check
or money order for
handling, return packing
and shipping charges.
Please include your
name, address and a
daytime phone number.
You must prepay shipping
charges. Send to:
Honeywell
Attn: Returns Department
4755 Southpoint Drive
Memphis, TN 38118
USA
5 YEAR LIMITED WARRANTY
HW-628 OM_eng 09/28/01 10:34 AM Page 7

GUIDE D’UTILISATION
TEMPERATURECONTROL
LOWHIGH
•
•
•
•
SUPERHIGH
OFFLOW
FRESH
AIR
EXHAUST
•
•
•
•
SUPERHIGH
OFFLOW
FRESH
AIR
EXHAUST
SPEEDSPEED
TWINDOWMC
VENTILATEUR DE FENÊTRE DOUBLE
Modèle HW-628
HW-628 OM_fre 10/01/01 2:07 PM Page 1