Honeywell HZ519 - Digital Low Profile Silent Comfort... User manual

IMPORTANT
SAFEGUARDS
READ AND SAVE THESE
SAFETY INSTRUCTIONS
BEFORE USING THIS HEATER.
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the
following:
IMPORTANT
INSTRUCTIONS
1. Read all instructions before using this heater.
2. This heater is hot when in use.To avoid burns, do not
let bare skin touch hot surface. If provided, use han-
dles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding,
papers, clothes, and curtains at least 3 feet (0.9 m)
from the frontof the heater and keep them away from
the sides and rear.
3. Extreme caution is necessary when any heater is
used by or near children or invalids and whenever
the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or
plug or after the heater malfunctions, has been
dropped or damaged in any manner. Return heater
to authorized service facility for examination, electri-
cal or mechanical adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathroom, laun-
dry areas and similar moist indoor locations. Never
locate heater where it may fall into a bathtub or other
water container.
8. Do not run cord under carpeting. Do not cover cord
with throw rugs, runners, or the like. Arrange cord
away from traffic area where it will not be tripped
over.
9. This heater is for use on 120 volts. The cord has a
grounded plug as shown in Fig. 1. An adapter is
available at retail (not included) for connecting three-
blade grounding-type plugs to two-slot receptacles.
The green grounding lug extending from the adapter
must be connected to a permanent ground such as a
properly grounded outlet box. The adapter should not
be used if a three-slot grounded receptacle is avail-
able.
10. This heater draws 12.5 amps during operation. To
prevent overloading a circuit, do not plug the heater
into a circuit that already has other appliances work-
ing.
11. It is normal for the plug to feel warm to the touch;
however, a loose fit between the AC outlet (recepta-
cle) and plug may cause overheating and distortion
of the plug. Contact a qualified electrician to replace
loose or worn outlet.
12. To disconnect the heater, first turn controls to the
OFF position, then grip the plug and pull it from the
wall outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or
exhaust in any manner. Do not use on soft surface,
like a bed, where openings may become blocked.
15. A heaterhas hot and arcing or sparking parts inside.
Do not use it in the areas where gasoline, paint, or
flammable liquids are used or stored.
16. Use this heater only as described in this manual.
Any other use not recommended by the manufac-
turer may cause fire, electric shock, or injury to per-
sons.
17. Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the
cord shall be No. 14 AWG minimum size and rated
not less than 1875 watts.
18. The output of this heater may vary and its tempera-
ture may become intense enough to burn exposed
skin. Use of this heater is not recommended for per-
sons with reduced sensitivity to heat or an inability to
react to avoid burns.
19. SAVE THESE
INSTRUCTIONS.
1
MODE
POWER
DIGITAL LOW
PROFILE HEATER
HZ-519 Series

2
BASIC CONTROL PANEL OPERATION:
POWER
MODE: SET TEMPERATURE
MODE: SET TIMER
IMPORTANT SAFETY INSTRUCTIONS
REGARDING THE PLUG ON YOUR
PRODUCT
•
•FIG 1
Continuous Run
•Press Power once to turn the heater on.
•Press Power again to turn the heater off.
Set Temperature
•Press Mode until the Temperature icon blinks. The
current room temperature will appear.
•Use the Up or Down arrows to set the desired tem-
perature.
•The Temperature icon will stop blinking and the cur-
rent room temperature will reappear after the desired
temperature is set.
•The heater will turn-off shortly after the desired tem-
perature is reached and the Power light above the
display will blink.
•The heater will turn back on when the room tempera-
ture drops approximately 2 degrees below the
desired temperature. The Power light will stop blink-
ing and will remain lit.
Timer
•Press Mode until the Timer icon blinks. The Hour
display will appear.
•Use the Up or Down arrows to set an operation time
between 1 and 10 hours.
•The heater will turn-off when time runs out.
Power
Mode
F/C
Back-Lit
Power
Mode
F/C
Back-Lit
o
70
F
Power
Mode
F/C
Back-Lit

3
FAHRENHEIT/CELSIUS
BACK-LIT DISPLAY
REMOTE CONTROL OPERATION
Two (2) AAA batteries required.
The HZ-519 is compatible with a Basic or LCD
Remote Control which can be purchased sepa-
rately at:
www.honeywellconsumerproducts.com
The Remote Control works the same as the cor-
responding buttons on the Control Panel display
on the heater and will show the appropriate icons
when the various functions are activated.
POWER
•MODE: SET TEMPERATURE
F/C Temperature
Display
•F/C feature functions from only the Power or Set
Temperature screens.
•Press the F/C button to toggle between Fahrenheit
and Celsius.
•The Back-lit feature provides light to the heater dis-
play and functions in any power or mode setting.
•Press the Back-lit button to toggle this feature on
and off.
Basic Remote LCD Remote
•Press Power once to turn the heater on.
•Press Power again to turn the heater off.
Power
•Press Mode until the Temperature icon blinks. The
current room temperature will appear.
•Use the Up or Down arrows to set the desired temper-
ature.
•The Temperature icon will stop blinking and the cur-
rent room temperature will reappear after the desired
temperature is set.
•The heater will turn-off shortly after the desired tem-
perature is reached and the Power light above the dis-
play will blink.
•The heater will turn back on when the room tempera-
ture drops approximately 2 degrees below the desired
temperature. The Power light will stop blinking and
will remain lit.
Basic Remote LCD Remote
Adjust Up or
Down
Mode
Temperature
Power
Mode
F/C
Back-Lit
Power
Mode
F/C
Back-Lit

4
•MODE: SET TIMER
BACK-LIT DISPLAY
TROUBLESHOOTING
If your heater shuts off unexpectedly, safety fea-
tures may have been activated to prevent over-
heating. If this happens:
•Be sure the heater is plugged in and that the
electrical outlet is working.
•Check your temperature setting. The heater
may simply be off because you have reached
your desired heat setting.
•This heater has a caution light located above
the control panel. DO NOT operate the heater
while the caution light is on.
•Check for any obstructions. If you find an
obstruction, turn the heater OFF and unplug it.
Allow the heater to cool completely, then
remove the obstruction. Wait at least 10 min-
utes, then replug in the heater, press Power
and follow the OPERATION INSTRUCTIONS.
•
For more troubleshooting tips, visit our website at:
www.honeywellconsumerproducts.com
NOTE: IF YOU CONTINUE TO EXPERIENCE A
PROBLEM, PLEASE RETURN THE HEATER
TO THE PLACE OF ORIGINAL PURCHASE OR
SEE YOUR WARRANTY. DO NOT ATTEMPT
TO OPEN THE HEATER YOURSELF. DOING
SO MAY VOID YOUR WARRANTY AND
CAUSE DAMAGE TO THE HEATER OR PER-
SONAL INJURY. IF YOU HAVE ANY QUES-
TIONS REGARDING THIS HEATER, PLEASE
CALL OR WRITE:
Honeywell
Consumer Relations Department
250 Turnpike Road
Southborough, MA 01772
Toll Free 1-800-332-1110
E-mail: [e-mail]
CLEANING AND STORAGE:
We recommend that the heater be cleaned at
least once a month and before off-season stor-
age.
•Turn the heater OFF and unplug it. Allow it to
cool completely.
•Use only a dry cloth to clean the external sur-
faces of the heater. DO NOT USE WATER,
WAX, POLISH, OR ANY CHEMICAL SOLU-
TION.
•Clean your heater using the above-mentioned
steps, then pack the heater in its original con-
tainer and store it in a cool, dry place.
•This heater does not disassemble.
ACCESSORIES:
Your heater is compatible with both a Basic or
LCD Remote Control. To upgrade your heater or
to get a listing of available accessories, visit our
website at:
www.honeywellconsumerproducts.com
•Press Mode until the Timer icon blinks. The Hour
display will appear.
•Use the Up or Down arrows to set an operation time
between 1 and 10 hours.
•The heater will turn-off when time runs out.
Basic Remote
LCD Remote
Adjust Up or
Down
Mode
Timer
•The Back-lit feature provides light to the heater dis-
play and functions in any power or mode setting.
•Press the Back-lit button to toggle this feature on
and off.
Basic Remote
LCD Remote
Back-lit

5
ELECTRICAL RATING:
This product is rated 12.5 Amps (1500 Watts) at
120 VAC, 60 Hz.
5 YEAR LIMITED WARRANTY
You should first read all instructions before
attempting to use this product. Register your
product on-line at
www.honeywellconsumerproducts.com or
complete and return the Customer Response
Card within 7 days.
A. This 5 year limited warranty applies to repair
or replacement of product found to be defec-
tive in material or workmanship. This warranty
does not apply to damage resulting from com-
mercial, abusive, unreasonable use or supple-
mental damage. Defects that are the result of
normal wear and tear will not be considered
manufacturing defects under this warranty.
•HONEYWELL IS NOT LIABLE FOR INCI-
DENTAL OR CONSEQUENTIAL DAMAGES
OF ANY NATURE. ANY IMPLIED WAR-
RANTY OF MERCHANTABILITY OR FIT-
NESS FOR A PARTICULAR PURPOSE ON
THIS PRODUCT IS LIMITED IN DURATION
TO THE DURATION OF THIS WARRANTY.
Some jurisdictions do not allow the exclusion
or limitation of incidental or consequential
damages or limitations on how long an implied
warranty lasts, so the above limitations or
exclusions may not apply to you. This warranty
gives you specific legal rights, and you also
may have other rights which vary from jurisdic-
tion to jurisdiction. This warranty applies only
to the original purchaser of this product from
the original date of purchase.
B. At its option, Honeywell will repair or replace
this product if it is found to be defective in
material or workmanship. Defective product
should be returned to the place of purchase in
accordance with store policy. Thereafter, while
within the warranty period defective product
may be returned to Honeywell.
C. This warranty does not cover damage result-
ing from any unauthorized attempts to repair or
from any use not in accordance with the
instruction manual.
D. Return defective product to Honeywell Con-
sumer Products with a brief description of the
problem. Include proof of purchase and a $10
US/$14.50 CAN check or money order for han-
dling, return packing and shipping charges.
Please include your name, address and day-
time phone number. You must prepay shipping
charges. Send to:
In the US:
Honeywell
Attn: Returns Department
4755 Southpoint Drive
Memphis, TN 38118 USA
In Canada:
Honeywell
Attn: Returns Department
510 Bronte Street S.
Milton, ON L9T 2X6 Canada