Honeywell 3518 User manual

Models 3518
LONG GUN / EXECUTIVE SAFE
READ THIS MANUAL CAREFULLY AND NEVER STORE IT INSIDE THE SAFE!
1
PACKAGE CONTENTS
•Operation Manual
•2 Override Access Keys
•4 “AA” Batteries
•Mounting Kit w/ Bolts
•2 Removable Shelves
•Removable Gun Rack
•12 Shelf Support Clips
•Internal Storage Box
DO NOT RETURN SAFE TO STORE!
For missing parts or difficulty operating your safe, please contact our
Consumer Assistance Department by telephone. Store will not accept
returned products without prior authorization. You must first contact our
consumer assistance department.
CONTACTING CONSUMER ASSISTANCE
EMAIL: [email protected]
ADDRESS:
Consumer Assistance Dept.
LH Licensed Products, Inc.
860 East Sandhill Avenue
Carson, CA 90746 USA
TELEPHONE: US/Canada 1-877-354-5457 (Toll Free)
CALL CENTER
HOURS:
US/Canada 7am – 5pm (PST) Mon - Fri
LOCATING SAFE IDENTIFICATION NUMBERS
When contacting Customer Service you will need to provide the following
information:
SERIAL NUMBER
Located on lower right corner on front of safe.
Do Not Remove Safe I.D. Tags!
KEY NUMBER
2 Digit Number etched on the metal collar
located around the key hole.

2
SETUP & OPERATION
NOTE: The Batteries have been preinstalled at the factory and the keypad is ready to
use.
OPEN SAFE WITH FACTORY PRESET PASS CODE
1. Using the digital keypad enter the factory preset pass code “ 1 - 5 - 9 - # ”.
2. Rotate handle clockwise and open door.
PROGRAM A NEW PASS CODE
1. With door open, press red reset button inside door
(Fig. 1).
2. Yellow light is on; enter new pass code in 30
seconds.
3. Enter new code (3 to 8 digits) followed by “ # ”.
4. Safe will beep and yellow light will turn off.
5. Do not close door before testing new pass code.
TEST NEW PASS CODE
1. With door open, rotate handle counterclockwise to put door bolts in lock
position.
2. Enter new code (3 to 8 digits) followed by “ # ”.
3. Green light is on; rotate handle clockwise within 5 seconds.
4. Lock bolts should recede into the unlocked position.
TO CLOSE THE SAFE
1. Make sure the lock bolts are in the unlocked position
2. Close the door and hold it in the closed position.
3. Rotate handle counterclockwise to engage the bolts and lock safe.
SECURE LOCKOUT PERIODS
If a wrong code is entered three times in a row, the digital keypad will begin a 20
second secure lockout period. During this secure lockout period the keypad will
become disabled.
Once the lockout period has expired, the safe can be unlocked using the correct pass
code.
OVERRIDE ACCESS KEY
Your safe if equipped with an emergency key lock, which allows immediate access in
case you forget your Pass code or the batteries need replacing.
1. Remove the key lock cover located beneath the keypad.
2. Insert one of the override keys (2 included) into the bypass lock and turn to the
left.
3. Rotate the spindle handle clockwise to the right, and then pull the door open.
4. After re-programming or changing batteries, replace the key lock cover and store
keys in a safe and secure location away from the safe.
IMPORTANT: The override key is used to gain access to the safe to change batteries
or if the digital lock fails to operate. This key should be stored in a secure place away
from your safe.
3
REPLACING BATTERIES
NOTE: The pass code will not be erased if the batteries become weak or are
removed.
The red light will come on if your batteries become week. If your batteries
are dead and you cannot open the safe by using the digital keypad, you must
use the override access key to open safe and access the battery
compartment.
1. Remove battery compartment cover on inside door.
2. Insert 4 “AA” batteries. DO NOT USE Non-alkaline or rechargeable
batteries
3. Replace the battery cover.
4. Do not close door before testing digital lock.
IF YOU FORGET THE PASSCODE
Use the override access key to open safe and program a new pass code.
ORDERING REPLACEMENT KEYS
The following information is required to order keys:
SALES RECEIPT & IDENTIFICATION
Copy of sales receipt showing Store, Date & Product Description.
Copy of your picture I.D. (Drivers license, passport, regular I.D.).
PRODUCT OWNERSHIP VERIFICATION FORM
Contact us by email or telephone to request a “Product Ownership
Verification Form”.
CONTACT INFORMATION PRODUCT
INFORMATION
Name & Shipping Address Safe Model #
E-mail address (If Available) Safe Serial #
Telephone Number Lock Key #
Best Time to Contact You Quantity of Keys Ordered
PAYMENT INFORMATION METHOD OF PAYMENT
Per Key: US/Canada - $12.00 (USD) Telephone: Visa or
MasterCard
Express Delivery: Contact us for Charges Mail: Check or Money
Order Subject to change without prior notification.

4
SAFETY PRECAUTIONS
The safe door is heavy. Do not open the door with the safe on an uneven or
unstable floor. Hanging on an open door may cause the safe to tip forward
when not lag-bolted to the floor, resulting in serious injury or death to
yourself or others. If you have or have occasion to have small children in
your home, please make sure you never leave your safe unsecured. It is
possible for small children to climb inside your safe and become locked in.
This could result in serious injury or death
APPROPRIATE USE OF YOUR SAFE
This Executive Safe protects records and many other valuables. Testing
shows that the interior temperature of the safe remains below 350°F (177°C)
for 25 minutes during a fire up to 1100°F (593°C) when used properly. Your
safe must be closed and latched in order to properly protect the contents
from fire.
SAFE CARE AND MAINTENANCE
When properly maintained, your safe will continue to operate for many years.
In order to ensure optimum performance of your safe, please follow these
simple precautions:
REPLACE BATTERIES – For best results and performance, we recommend
that the batteries be replaced at least once a year or sooner depending on
amount of use.
CLEAN HANDS - Never attempt to operate the digital keypad if your hands
have excessive dirt, debris or liquids on them.
CLEAN SAFE – To clean the surface of your safe, it is recommended that
you use a mild cleaner (e.g., window cleaner) to avoid scratching or
discoloring the surface. Always wipe dry and NEVER use abrasive cleansers
on the safe or digital keypad.
MOISTURE – We recommend that you place delicate items such as pictures
or intricate jewelry into an air-tight container before storing them in your safe.
Avoid placing your safe in areas of high humidity. For optimum performance,
the safe should be opened and aired out for at least 20 minutes every two
weeks.
For future reference, store this Operation and Installation Guide in a secure
area away from the safe. DO NOT DISCARD!
MOVING YOUR SAFE
Before moving your safe, verify the load bearing weight of the floors and
stairs, and types of flooring the safe will be moved over (tile, wood, and other
flooring can be damaged by the weight of the safe). To determine whether or
not your safe will make it through doorways, stairs or corners take the empty
safe box and see if it will fit all the way through to its final location.
5
PLACEMENT OF YOUR SAFE
Proper installation and anchoring are critical to the security of your safe.
Install near a load-bearing wall to support the weight of the safe.
To help protect the exterior finish of your safe, install inside in a dry location
where there is climate control (heat in the winter and cooling in the summer).
ANCHORING YOUR SAFE
You may bolt the safe to the wall or floor to increase protection from theft
and resistance to tipping. This safe was manufactured with bolt down holes
pre-drilled in the back panel and floor panel. To secure your safe to the wall
and/or floor:
1. Remove the liner from the back and/or floor of safe and locate the
pre-drilled holes.
2. Anchor the safe using the mounting hardware kit which includes (2)
3” x 3/8” lag screws and anchors. Securing back of safe to wall studs
is important.
3. Once completed, replace protective liners.
NOTE: Bolting/unbolting of the unit is at the consumer’s expense and
discretion. LH Licensed Products is not responsible for any costs incurred if
the unit is to be replaced.
If you have any questions about mounting the safe, please check with your
local home center/hardware retailer or independent contractor.
INSTALLING SHELVES
This safe includes (2) adjustable/removable shelves and (1) gun rack.
To install:
1. Remove shelves, gun rack and (12) shelf support clips from protective
wrapping.
2. Each shelf will require (4) support clips.
3. Determine the desired location of your shelf and/or gun rack and note
the corresponding support guide slots on the vertical standards that
are best suited to support the shelf in that location.
4. Insert (1) support clip into each of the vertical standards. The top of
the support clip should be placed into the selected slot first and then
the bottom of clip will lock in place when pushed back.
IMPORTANT: Make sure all (4) clips are installed at the same height
on the vertical standards so that the shelf is level.
5. Install the shelf into position by placing inside the safe (tilting if
necessary) and lowering into position on the support clips.
6. Repeat procedure for 2nd shelf. HINT: If shelves are not being used,
they can be stored in the bottom of the safe.
LOADING YOUR SAFE
Store documents and ammunition in the bottom of the safe for greatest
protection against fire damage. If you are storing electronic media, use a
Media Cooler (not included) to provide additional protection. Do not put
anything in your safe that will put pressure against the door when it is closed.
If you live in a humid environment, it is recommended that you use a
dehumidifier or desiccant to protect the contents from rust or mildew.

6
LIMITED WARRANTY
LH Licensed Products, Inc., (“LHLP, Inc.”) warrants that for a period of seven
(7) years from the date of purchase, this product will be free from structural or
mechanical defects resulting from materials or workmanship. LHLP, Inc., at its
sole option and as the purchaser’s sole remedy under this warranty, will repair
or replace this product or any component of the product found to be defective
during the warranty period. Replacement or repair will be made with a new or
remanufactured product or component. If the product is no longer available,
replacement may be made with a similar product of equal or greater value.
THIS IS YOUR EXCLUSIVE WARRANTY.
This warranty is only valid for the original retail purchaser from the date of
initial retail purchase and is not transferable. You must keep the original sales
receipt. Proof of purchase is required to obtain warranty service.
LHLP, Inc. dealers, service centers, or retail stores selling this product do not
have the right to alter, modify or in any way change the terms and conditions
of this warranty.
This warranty does not apply to the finish on the product. This warranty does
not cover normal wear and tear of parts or damage resulting from any of the
following: negligent use or misuse of the product, use contrary to the
operating instructions, disassembly, repair or alteration by anyone other than
LHLP, Inc. or an authorized service center, improper installation, or exposure
to extremes of heat or humidity. Further, the warranty does not cover Acts of
God, such as fire, flood, hurricanes and tornadoes.
LHLP, Inc. shall not be liable for any incidental or consequential damages
caused by the breach of any express or implied warranty or otherwise relating
to the sale of this product. LHLP, Inc. is also not responsible for: costs
associated with removing or installing the product; damage or loss of the
contents of the product; nor for the unauthorized removal of the contents; or
damages incurred during shipment.
THE ABOVE WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, AND
LHLP, INC. DISCLAIMS ANY AND ALL OTHER COVENANTS AND
WARRANTIES.
Except to the extent prohibited by applicable law, any implied warranty of
merchantability or fitness for a particular purpose is limited in duration to the
duration of the above warranty period. Some states, provinces or jurisdictions
do not allow the exclusion or limitation of incidental or consequential
damages or limitations on how long an implied warranty lasts, so the above
limitations or exclusion may not apply to you. This warranty gives you specific
legal rights, and you may also have other rights that vary from state to state,
or province to province, or jurisdiction to jurisdiction.
7
Manufactured by
LH Licensed Products, Inc.
860 East Sandhill Avenue
Carson, CA 90746
The Honeywell Trademark is used under license from
Honeywell International Inc. Honeywell International Inc.
makes no representations or warranties with respect to
this product.
REV. 10-15-2012