Howard Miller HEKMAN 23760 User manual

STEP 7 : Thread the flat washer(5) , JCB bolt (1) to leg (B) .tighten bolts in step 6 fully with allen wrench (6) then carefully turn the table upright.
STEP 6 : Align hole in center leg (D) with holes on bottom of dresser (A) and slide it into position.
STEP 5 : Tighten bolts in step 6 fully with allen wrench (6) & wrench (9) then carefully turn the buffet upright.
STEP 4 : Set base assembly on the upside down case and attach with bolt (1) and washer (5) using allen wrench (6).
STEP 3 : Thread the HEX. bolt(7) to iron leg(B) & iron cross bar(C).using small washers(8) tighten end assemblies fully.
STEP 2 : Roll dresser on its back, then on its top on a clean, soft surface.
STEP 1 : Unpack dresser and remove drawers.
6
5
5
6
2
8
7
9
1
Wrench
Flat washer M8X18 MM
Bolt M8X20 MM
1
4
4
Allen wrench
20
Flat washer M8X25 MM
4
4
JCB Bolt M6 X 50MM
JCB Bolt M6 X 40 MM
9
8
7
6
5
4
3
2
JCB Bolt M6 X 30 MM2
1JCB Bolt M6 X 20 MM 10
C
ITEM
A
1
ASSEMBLY INSTRUCTION FOR 23760 DRESSER
TO ASSEMBLY :
AAAA HHHHOOOOWWWWAAAARRRRDDDD MMMMIIIILLLLLLLLEEEERRRR CCCCOOOOMMMMPPPPAAAANNNNYYYY
STEP 8 : Install drawers.
QTY.DESCRIPTINNO.
HARDWARE LIST
Page 1/2
D
B

IF REQUIRED TO FIX THE MIRROR WITH CABINET :
4
6
6
3
5
5
E
F
AAAA HHHHOOOOWWWWAAAARRRRDDDD MMMMIIIILLLLLLLLEEEERRRR CCCCOOOOMMMMPPPPAAAANNNNYYYY
Page 2/2
ASSEMBLY INSTRUCTION FOR 23760 DRESSER & 23768 MIRROR
Please align the holes of wooden support (E) and holes available at back of cabinet.
tighten it by using allen wrench (6) ,JCB bolt (3) & washer (5).
Align hole wooden support (E) and mirror (F) tighten it by using allen wrench (6) ,JCB bolt (4) & washer (5).